answersLogoWhite

0

What else can I help you with?

Related Questions

If an electric furnace draws 80 amperes at 220 volts and the temperature increase across the furnace is 60F what should be the airflow in cubic feet per minute?

927 cfm


What is the typical voltage drop across a photodiode?

The photodiode's voltage drop varies with the temperature and current flowing through it. The typical voltage drop (VBIAS - VREF) across the MAX4007 series is 0.8V, with a guaranteed maximum of 1.1V.


Why use LMTD and not mean temperature difference?

Because the temperature change that occurs across the heat exchanger from the entrance to the exit is not linear, and a logarithmic function best describes this temperature change.


What is the difference between thermocouple and RTD?

A thermocouple measures temperature difference between two points, producing a tiny voltage corresponding to the difference in temperature. To measure temperature with a thermocouple, you need to know the temperature of one junction and calculate the difference from the table or equation for the type of t/c used. An RTD changes resistance in response to temperature--to measure temperature with an RTD you measure its resistance (usually by putting a known voltage across it and measuring the current).


What is the diameter of a hurricane and of its eye?

A typical hurricane is about 300 miles across while a typical hurricane eye is 20 to 40 miles across.


What is the age of york furnace with the following numbers p2mpd20n09601c serial emcm571988?

Hi I have that furnace in my house and i came across your post when i did a model number search for parts. My house was built in 1995 and the furnace was brand new then. Hope this helps.


What should be the delta T across a typical pool heater?

??????


What you will do to raise the temperature difference without changing the current?

To raise the temperature difference without changing the current, you can increase the resistance in the circuit. This can be done by adding additional resistors in series, using a material with higher resistance, or by adjusting the configuration of the circuit to increase the overall resistance. By increasing the resistance, the same current will produce a greater voltage drop across the resistors, resulting in a higher temperature difference.


Do hurricanes cover more area than tornadoes?

Yes, far more. The typical tornado is a few hundred feet across. The typical hurricane is a few hundred miles across.


Which continents that's spread across the three temperature zones?

Whichcontinents that's spread across the three temperature zones


How does a thermopile work?

A thermopile is a device that generates electrical voltage when exposed to a temperature gradient. It consists of multiple thermocouples connected in series, which produce a cumulative voltage output. When one end of the thermopile is heated and the other end is cooled, a voltage difference is generated due to the temperature difference across the thermocouples.


What is the size of a typical granule or convection cell seen in the photosphere?

The size of a typical granule seen in the photosphere is about 1000 km across.