High power transmission lines carry several hundred amperes up to 2000 amps at voltages up to 500 kV or higher
Number 6 gauge wire typically has an ampacity rating of around 55-75 amps and a voltage rating of 600 volts. These ratings may vary depending on the specific type of wire and the regulations in your area. It is important to consult the National Electrical Code (NEC) or a qualified electrician for accurate information.
It depends on the voltage on line side. KVA is simply thousand volt-amps, so you need to know voltage in order to calculate amperes.Another AnswerThe rated primary current is the rated apparent power of the transformer, divided by the rated primary current. However, the actual primary current is determined by the actualsecondary load current in proportion to the reciprocal of the turns ratio.
A fuse rating of 5 amps means that the fuse will break the circuit if the current passing through it exceeds 5 amps. It acts as a safety measure to protect the circuit from damage due to excessive current flow.
To determine the battery's capacity in amp-hours (Ah), you multiply the current (in amps) by the time (in hours). In this case, a battery that can produce six amps for four hours has a capacity of 6 amps × 4 hours = 24 amp-hours. Therefore, the current rating of the battery is 24 Ah.
According to NEC, it's max rating in free air is 18 amps.
It its rating is 63 amps that means the current can be anything from 0 to 63 amps but not more.
The maximum current rating in amps for a 10 AWG wire is typically around 30 amps.
The maximum current rating for the circuit breaker that can handle a load of 40 amps is 40 amps.
The maximum current rating for a 2 pole breaker that can handle 25 amps is 25 amps.
The maximum current rating for a wire that can safely handle 10 wire amps is 10 amps.
The maximum current rating for the circuit breaker is 150 amps.
The maximum current rating for the circuit breaker needed for a device that operates at 20 amps is 25 amps.
Number 6 gauge wire typically has an ampacity rating of around 55-75 amps and a voltage rating of 600 volts. These ratings may vary depending on the specific type of wire and the regulations in your area. It is important to consult the National Electrical Code (NEC) or a qualified electrician for accurate information.
15 amps 120 volts AC
2500 Amps
For all intents and purposed the VA rating is the same as the wattage rating of appliances. VA is an electrical classification for Volt Amps. The formula for watts is, Watts = Amps x Volts.
Yes. Because... If we connect an alternator to a transmission line of high capacitance the line voltage will increase and caused a line voltage difference, which does not satisfied the condition of parallel operation of same voltage rating. [By Akhtaruzzaman08]