0
What else can I help you with?
Hop Count and are used to calculate metrics?
Hop Count refers to the number of intermediary devices that data packets must pass through to reach their destination. It is commonly used in routing algorithms to determine the shortest path between source and destination nodes. Metrics, on the other hand, are quantitative measures used to evaluate network performance, such as latency, throughput, or packet loss. Hop Count can be a metric in itself, as it gives an indication of network efficiency and can impact overall performance.
What is Ns2 is an example of?
Ns2 is an example of a discrete event network simulator used for research in network communication and protocols. It allows researchers to simulate complex network scenarios, study the performance of network protocols, and analyze packet routing and congestion control algorithms in a controlled environment.
How do you calculate metrics?
Hop count & administrative distance. This is a measure used by the routing protocol to calculate the best path to a given destination, if it learns multiple paths to the same destination. Each routing protocol uses a different metric.
What is ss7 signaling?
SS7 signaling is a set of protocols used in telecommunications networks to handle the exchange of signaling messages. It allows for call setup, routing, and other essential functions in telecommunication networks. SS7 helps in establishing and managing connections between different network elements for services like voice calls, SMS, and data communication.
Types of air filters used in microbiology?
High Efficiency Particulate Air (HEPA) filters are used in microbiological containment protocols.
Which technology can be used in distance vector routing protocols to prevent routing loops?
Which two technologies can be used in distance vector routing protocols to prevent routing loops?
Which two technologies can be used in distance vector routing protocols to prevent routing loops?
Which two technologies can be used in distance vector routing protocols to prevent routing loops?
What is the difference between interior and exterior routing protocols?
Interior routing protocols are used to communicate within a single autonomous system. Exterior routing protocols are used to communicate between multiple autonomous systems.
What is the differences between routing and routed protocols?
Routing protocols are used by routers (RIP, EIGRP, OSPF) Routed protocols are the actual protocols on the wire (TCP/IP)
What two metrics are used by EIGRPs routing algorithm to calculate route metrics?
Delay and bandwidth
Which command displays the commands used to configure the routing protocol on this router?
The command used to display the commands that configure the routing protocol on a router is show running-config. This command provides a comprehensive view of the current configuration, including any routing protocols like OSPF, EIGRP, or BGP. To focus specifically on routing protocols, you can also use show ip protocols, which summarizes the active routing protocols and their settings.
Which two technology can be used in distance vector routing protocol to prevent routing loop?
Which two technologies can be used in distance vector routing protocols to prevent routing loops?
What variables are used to determine routing metrics?
mtu, bandwidth, delay, reliability, load
When should distance vector routing be used?
Distance vector routing is used when the network is simple and has no hierarchical design. Examples of distance vector routing protocols are RIP and IGRP.
What are two functions of the network command used when configuring routing protocols?
READ you're ccna cisco routing book.
What two variables are used to determine which candidates are selected for the routing table?
administrative distance and metrics
Which protocol routes between different autonomous systems?
The protocols used to distribute routing information between AS's are known as Exterior Gateway Protocols (EGP's).
