phosphoric acid
It may take a few hours to overnight for Coca-Cola to remove rust from a nail. The acid in the soda can help break down the rust, but the effectiveness may vary depending on the amount of rust and time left to soak.
To remove rust from metal, you can use a wire brush or sandpaper to scrub off the rust. You can also use a chemical rust remover or a homemade solution of vinegar and baking soda to dissolve the rust. Once the rust is removed, make sure to properly clean and dry the metal to prevent further corrosion.
It depends on the quality of the nail. If it is painted it Amy take long to rust. In general it may take a month or so for the nail to rust.
Yes it can kill you. Most rust contains strands of streptococcus. When streptococcus enters straight into the bloodstream the virus can eat away the skin on your body. For example, its likely you may wake up with half your face decayed off. IT IS BAD. THROW IT AWAY. Use surgical stainless steel. It doesn't rust.
Rust is caused by oxygen combining with the metal, in this case iron and steel. The Acid in the cola strip off contaminants and increase the speed at which this process takes place. Acid also has oxygen in it and when it meets up with various other items it makes more oxygen available for the process. Oil protects by preventing oxygen from getting to the metal.
It may take a few hours to overnight for Coca-Cola to remove rust from a nail. The acid in the soda can help break down the rust, but the effectiveness may vary depending on the amount of rust and time left to soak.
No. At least it shouldn't. Cola should only be strong enough to slowly corrode off rust. If the cola is strong enough to take an eggshell off, then they screwed up the recipe.
It's said that Coca Cola can take the rust off of a rusty nail.
It depends if the nail is galvanized (coated) or not. If it isn't, I doubt it because the alcohol is actually take away the rust, or at least cover it up.
Coca-Cola, like all soft drinks, contains carbonic acid which will dissolve rust to some degree, but the rust-cleaning benefits are offset by the sugar residue left behind. Simple soda water would be more effective in this case. If the purpose of dissolving rust is to free parts that have been bound by corrosion, an industrial penetrating lubricant such as Kano Kroil would be better-suited to the task. Kroil is known by industrial mechanics as the best penetrating lubricant on the market. However, it is not readily available from retail outlets. The best source is from the manufacturer's website at http://kanolabs.com
It depends on the state or area it is from. Some states use chemicals on there roads that increase corrison. The other thing is it would take a long time for the heavy metal parts to rust away due to the mass; like frame rails, suspension, and brake parts.
diet cola because it has more sugar
diet
Your lungs.
To remove rust from metal, you can use a wire brush or sandpaper to scrub off the rust. You can also use a chemical rust remover or a homemade solution of vinegar and baking soda to dissolve the rust. Once the rust is removed, make sure to properly clean and dry the metal to prevent further corrosion.
If they are an alloy, they will eventually rust.
If you go to any hardware store such as Home Depot or Lowes you can buy a can of rust remover. WD40 is good example of a rust remover. It is a simple spray. Lemon juice and baking soda are also simple household products that can help remove rust from metal. Cola soda is a good all round metal cleaner. It might take a bit longer than proprietary brands. Put the hinge in a bowl of the stuff and be patient.