centimeters
Just finished this unit in 6th grade science :) Plate tectonics means that the plates are in slow, constant movement. There is no start and end.
The rigid section of the lithosphere that moves as a unit is known as a tectonic plate. These plates are large, solid slabs of rock that make up the Earth's surface and float on the semi-fluid asthenosphere beneath them. Tectonic plates can interact at their boundaries, leading to geological phenomena such as earthquakes, volcanic activity, and mountain formation. The movement of these plates is driven by forces such as mantle convection, slab pull, and ridge push.
* A hot plate should measure temperature because when you use it, it will boil because of the heat coming up. Since there is heat, it measures temperature.
Centimeters would be most convenient metric unit for the diameter of a dinner plate.
You would likely use centimeters per year (cm/yr) or millimeters per year (mm/yr) to describe the speed of Earth's tectonic plates as they move along plate boundaries. These units are commonly used in geology to measure the rate at which plates are moving relative to each other.
Just finished this unit in 6th grade science :) Plate tectonics means that the plates are in slow, constant movement. There is no start and end.
Plate
A Tectonic Plate
inches
Geologists call a crustal landmass that moves as a unit a tectonic plate. These plates float on the semi-fluid asthenosphere beneath them and interact at plate boundaries by either moving apart, colliding, or sliding past each other, leading to various geological phenomena.
As far as I know, there is no measure of movement of air, but if you really are persistent, you can use balloons.
* A hot plate should measure temperature because when you use it, it will boil because of the heat coming up. Since there is heat, it measures temperature.
Centimeters would be most convenient metric unit for the diameter of a dinner plate.
You would likely use centimeters per year (cm/yr) or millimeters per year (mm/yr) to describe the speed of Earth's tectonic plates as they move along plate boundaries. These units are commonly used in geology to measure the rate at which plates are moving relative to each other.
Measure the plate resistors' (R) voltage (E) and use Ohms law to convert that to amps (I). I=E/R
Centimeters. Meters would be too large, and decimeters aren't often used.. You could potentially use decimeters, but centimeters would work better.
As far as I am aware, CO is not a unit of measure.