answersLogoWhite

0

A T-tube is typically removed 6-12 weeks after gallbladder removal surgery to allow the bile duct to heal. The specific timing may vary depending on individual circumstances and the surgeon's preference. It is important to follow your healthcare provider's instructions for optimal recovery.

User Avatar

AnswerBot

1y ago

What else can I help you with?

Related Questions

How do you install t-5 fluorescent tubes?

To install T-5 fluorescent tubes, first turn off power to the fixture. Gently twist and remove the old tube by rotating it slightly and pulling it out of the socket. Insert the new T-5 tube by carefully aligning the pins with the socket and gently twisting until it locks in place. Turn the power back on and test the new tube.


Can T tube be flushed?

Yes, a T-tube can be flushed with saline solution to maintain patency and prevent blockages. It is recommended to follow the healthcare provider's instructions on how to properly flush a T-tube.


How do you remove and install a ford windstars dipstick oil tube?

how to remove broken dipstick tube ford winstar


How can I remove a tube light?

To remove a tube light, first turn off the power to the light fixture. Then, gently twist and pull the tube light out of the sockets on either end. Be careful not to break the tube light as you remove it. Dispose of the old tube light properly and insert a new one if needed.


How do you remove a water tube from a Honda Accord 91 ex?

How do you remove a water tube from a Honda accord 91 ex


How do you replace an oil dipstick tube on a 1999 Honda civic?

remove bolts and clip. Then remove oil dipstick tube.


Where do you find the thermostat on an 2002 blazer?

Follow top radiator hose to where connects at engine, hose is connected to metal tube held down by 2 small bolts usually. Remove tube and t-stat is located underneath.


Why is t-tube called t-tube?

It stands for Transverse Tubuals. They run on the inside and throughout the structure of a skelatol muscle fiber.


How do you remove favourite videos from your channel on You Tube?

press remove video


How do you remove oxygen from a test tube?

To remove oxygen from a test tube, one method is to displace it with an inert gas, such as nitrogen or argon. By flushing the test tube with the inert gas, the oxygen is pushed out. Another method is to create a vacuum inside the test tube to remove the oxygen. This can be done using a vacuum pump or a syringe to pull the air out of the tube.


What are the steps in venipuncture?

Gloves Tourniquet Feel for a Vein Alcohol Stick Insert tube and fill Remove tube Remove tourniquet Remove needle Apply pressure Band aide


what is the Rick roll link?

ht t ps://w ww.you tube. co m /w atch?v =dQw4w 9WgX cQ There Remove spaces