answersLogoWhite

0

look on lower radiator hose, or under exhaust manifolds in the frost plugs. ona diesel the heater looks like a spark plug by the oil filter

User Avatar

Wiki User

19y ago

What else can I help you with?

Continue Learning about Natural Sciences

How should you unplug an electrical cord?

To unplug an electrical cord, simply grasp the plug firmly and pull it straight out of the outlet. Avoid pulling on the cord itself to prevent damage. Make sure to disconnect the plug by the head, not the cord.


Can you use 6 gauge wire on A extension cord and put 30 amp plugs on it?

If your question is can you use a #6 flexible SOOW cord and put a 30 amp plug on it, then yes. The breaker that feeds the receptacle that the cord will plug into can be no larger than a 30 amp breaker. What limits the cord capacity to 30 amps is the ratings of the plug on the end of the cord.


What does cord-and-attachment-plug-connected means?

"Cord-and-attachment-plug-connected" refers to a device that is powered by a cord (electrical cable) attached to an electrical outlet via a plug. This type of connection allows for easy removal and relocation of the device without the need for hardwiring.


Can you plug a 2 prong extension cord into a 3 prong extension cord?

I don't know about an extension cord, but they do sell plug adabters. You can pick them up at any hardware store or even Wal-Mart. They are ussaully grey or orange , and look like the plug end of the extension cord. One end will have the 2 prong, the other side will have the slots to plug in the three prong.


What protection is offered by the cord grip in a plug?

The cord grip holds the power cord of the appliance firmly to the plug body. If this is loose or absent then the cord is reliant on the electrical terminals to hold it in place. The copper wire terminals are weak and can easily break. In the UK the 'Earth' wire, which protects the user from electric shock, is the last wire to fail if the power cord is accidentally tripped over.

Related Questions

Spark plug gap 2000 f150 4.6?

www.motorcraft.com shows the spark plug gap as .044 inch


How to replace block heater cord on 2000 Malibu?

To replace the cord for a block heater on a 2000 Malibu, unplug the old cord from the block and plug in the new one. The end of the block heater cord can be found by tracing the cord back to where it is plugged into the motor.


Diagram for spark plug wiring diagram 2000 f150?

The spark plug wiring diagram for a 2000 F-150 can be found in its service manual. The service manual is available from Ford.


Your 2000 Ford F150 is running rough after you changed the pluges and plug wires?

If you didn't replace one spark plug wire at a time you may have mixed up the firing order.


Spark plug location F150?

sparkplug placement for 97 f150 4.6


What is the purpose of the plug on the cord?

The purpose of the plug on the cord is to connect the cord to an electrical outlet so that electricity can flow through the cord and power the device it is connected to.


Is it acceptable by OSHA to plug an extension cord into another extension cord-?

You can plug an extension cord into another extension cord. A extension cord is to help make doing something easier.


What are the safety considerations when using an extension cord with a removable plug?

When using an extension cord with a removable plug, it is important to ensure that the plug is securely attached to the cord to prevent any electrical hazards. Make sure the plug is compatible with the cord and that it is inserted fully and securely. Inspect the cord for any damage or fraying before each use, and avoid overloading the cord with too many devices. Always unplug the cord by pulling on the plug itself, not the cord, to prevent damage.


Does a 1999 Ford F150 4.6L V8 have spark plug wires?

Yes , its EDIS ( Electronic Distributorless Ignition System ) so it should have spark plug wires ( I believe in 2000 the 4.6 L went to Coil On Plug - C.O.P. )


How can I replace a plug on a cord?

To replace a plug on a cord, first cut off the old plug and strip the insulation from the cord wires. Then, attach the wires to the new plug following the manufacturer's instructions. Make sure to secure the wires properly and test the connection before using the cord.


What is the firing order for a 2000 ford f150 5.4 liter?

1 - 3 - 7 - 2 - 6 - 5 - 4 - 8 coil on plug ignition


What is the spark plug gap for a 1995 F150 5.0?

The spark plug gap is .054"