To set the clock on a Saturn L300, turn the ignition to the "On" position without starting the engine. Press the "Menu" button on the dashboard until you see the clock display. Use the "Hour" and "Minute" buttons to adjust the time. Once set, press the "Menu" button again to save the changes.
To reset the Body Control Module (BCM) on a 2001 Saturn L300, first disconnect the negative battery cable and wait for about 10-15 minutes. This allows the system to reset. Reconnect the battery cable, then turn the ignition to the "ON" position without starting the engine for a few seconds before starting the vehicle. This process can help clear any stored error codes and reset the BCM.
A defective brake light switch could cause the problem. Also a defective turn signal switch could also. The brake lights work through the turn signals. It cancels the brake light so that the turn signal can work.
Saturn (Greek: Cronus) was the son of Earth & Sky, two of the most primal gods who in turn were born out of Chaos. Saturn then castrated his father and became king of the universe, and was the father of Jupiter (Greek: Zeus.) Saturn was overthrown by his son, Jupiter and he became ruler of the gods.
It takes Saturn equivelent to 29 years to complete a full turn around the sun and it takes Saturn 10.5 hours to complete a turn on its axis. (Therefore a year on Saturn is equivelent to 29 years on Earth and a day on Saturn is 10.5 hours)
the signal flasher is the hazard light switch......remove the radio bezel and change the switch
The 2005 Saturn L300 does not have an inertia switch ¹. Instead, here are the locations of the fuses and relays in the Saturn L300 ²: Cigar lighter (power outlet) fuses in the engine compartment Fuse boxes under the instrument panel on the right and left side of the vehicle Engine compartment fuse box
mine is on the passenger at the foot of the instrument panel.
To find your turn signal fuse, check your owners manual. You will find a diagram of all the fuses and the location of each.
In a 2002 Saturn L100, the turn signal fuse is located in the fuse box, which is typically found under the dashboard on the driver's side. To access the fuse box, you may need to remove a cover panel. The specific fuse for the turn signals is usually labeled in the fuse diagram, which is often found on the cover or in the owner's manual. If the turn signals are not functioning, check this fuse for any signs of damage or a blown connection.
how do you fix turn signal
The 2003 Mitsubishi turn signal fuse can be found in the fuse box. The turn signal fuse will be in the second column, fourth from the top.
In the fuse box.
there is a constant buzzing from fuse box until signal or hazards are activated or until turn signal fuse is pulled
The turn signal fuse for a 2004 Ford Explorer is located in the fuse box under the dashboard on the driver's side. Specifically, you can find the fuse box by removing the cover panel beneath the steering column. Inside, look for the fuse labeled "Turn Signal" or "Flasher" in the fuse diagram. If the fuse is blown, replacing it should restore the turn signal function.
if only one turn signal is out your looking at a blown bulb not a fuse as the turn signals are on one fuse if it blew none of your signals would work but to check anyway look in manual to find which fuse is turn signal fuse located fuse box and pull it
It sounds like your "Timing Belt" broke. Have it checked, if it's broken it should cost around $200 to have it replaced on your six cylinder L300.