on the back of the block ,below the intake
The MAP sensor in a 1986 2.9 liter engine is a manifold absolute pressure sensor that measures the pressure inside the intake manifold. This information is used by the engine control module to calculate air/fuel mixture and ignition timing for optimal engine performance.
1 liter empty gasoline bottle will hold 1000 ml of oil
The oil pressure sensor on a 2006 Saturn Relay with a 3.9L engine is located on the engine block, typically near the oil filter. It is positioned on the driver's side, towards the rear of the engine, making it somewhat accessible from underneath the vehicle. To locate it easily, follow the oil filter, as the sensor is usually situated nearby.
A 5.3 liter motor typically requires around 6 to 7 liters of oil for a complete oil change, taking into account oil filter replacement and oil consumption during operation.
1KG of transformer oil will sum up to 0.815litres.
There are many 4.3 liter engines. In order to know where the oil pressure sensor is located in a 4.3 liter engine, the brand would need to be known.
where is the oil pressure sensor located on a 2005 frontier 4 liter v6 thanks
just to the right of the oil filter
The oil pressure sensor is located on the back of the engine, next to the distributor.The oil pressure sensor is located on the back of the engine, next to the distributor.
Yes, It has a crank sensor. Its located above the oil filter on a 2.4 liter engine. Remove the oil filter for easier access.
it is located in the distributor base. look above/right of the oil filter. for a 4 liter engine
It is on the back of the block, above the oil pan and left of the exhaust.
right above the oil filter
Under the fuel injector rail just above the oil pan. You can only see it if you are under the car looking at the oil filter. The sensor is 25 cm to your left next to the oil pressure sensor.
By the Oil Filter, underneeth the intake manifold.
It's at the top rear of the engine near the distributor.
The oild pressure sensor Is below the oil filter on the engine block. The knock sensor is above the oil filter. The vtec oil pressure sensor is on the block next to the distibutor. For a Vtec model and the 2.3 liter models(on the Si-Se models). On the 2.2 non-vtec(S model) I believe it is on the block above the oild filter