krypton
rms stands for root mean squared. rms voltage is a way of measuring a sort of average alterating current voltage as distinguished from peak-to-peak voltage. Likewise for ac rms current.
RMS (Root Mean Square) power ratings, such as 150 RMS, refer to the continuous power output of an audio system. To convert RMS power into watts, you can directly equate them, as RMS is a measure of watts. Therefore, 150 RMS is equivalent to 150 watts.
Rms is watts that's the amount of watts a speaker is rated for.
Yes, if it is set to measure AC, it is usually calibrated to RMS.
The ten most famous ocean liners of the 20th century include the following: the RMS Queen Mary II, the SS Rex, the SS France/SS Norway, the SS Bremen, the RMS Mauretania, the SS United States, the RMS Olympic, and the RMS Queen Elizabeth II.
The root-mean-square (rms) speed of a gas molecule is proportional to the square root of its temperature and inversely proportional to its molar mass. Since neon and argon gases are at the same temperature, the ratio of their rms speeds will be the square root of the ratio of their molar masses. Therefore, to find the rms speed of argon atoms, you need to calculate the square root of the ratio of the molar masses of argon to neon (molar mass of argon/molar mass of neon) and multiply it by the rms speed of neon.
Bridge rectifiers have higher rms values because the ripple factor low.
RMS watts is not a real measurement. The correct measurement is "average power", which is measured in "watts". It is dervied from RMS voltage, but that doesn't make it "RMS watts". "RMS watts" would be 22% higher than the correct "average watts".
rms means root mean square, or in a roundabout way the average. Therefore the average velocity or average speed (of a car?)
It means root mean square. it is a notation for speed......
RMS velocity refers to the root mean square velocity of particles in a gas, which is the square root of the average of the squares of the velocities. It is a measure of the average speed of gas particles in a system.
The measure for the average speed of air molecules is typically calculated using the root mean square (RMS) speed formula, which considers the distribution of speeds within the gas. The RMS speed provides a representative value that takes into account the kinetic energy of individual molecules in the gas sample.
RMS velocity is used to characterize the average velocity of molecules in a gas because it accounts for both the speed and direction of particles. Mean velocity, on the other hand, only describes the overall average speed of particles without considering their directions. RMS velocity gives a better representation of the kinetic energy and behavior of gas molecules.
RMS stands for "root mean square", and it represents an average of sorts. If you are interested in more technical details, or actually want to calculate RMS, the Wikipedia article on "root mean square" gives you a good overview. Note that for continuously changing values (as opposed to a few discrete measurements) this requires a knowledge of calculus, specifically integration.
You don't need exactly one cycle data for computing the RMS value. It is just a convenient normalization. 1 cycle = 1Hz. RMS values can also be specified in 1 Mcycle, 1kcycle, even 2.39384kcycles. Again, 1 cycle is simply convenient. In other words, if the RMS value were specified in MHz, the RMS value will be 20*log(MHz/Hz) higher.
RMS
rms is the best because 1 RMS = 100 PMPO