gastropoda
Hardness in torsion refers to the resistance a material has to deformation when subjected to torsional (twisting) forces. It is a measure of the material's ability to withstand twisting without undergoing plastic deformation. Hardness in torsion is important in applications where components are subject to torsional loading, as it indicates the material's resistance to structural failure under twisting forces.
The units of torsion are force multiplied by distance, typically measured in units of Newton-meters (Nm) in the International System of Units (SI) or pound-feet (lb-ft) in the imperial system.
The value of a torsion balance scale can vary widely based on its age, condition, brand, and specific features. On average, a basic torsion balance scale can range from $50 to $200, while rare or antique models may be worth several hundred to several thousand dollars. It's best to research current market prices or consult with antique dealers or collectors for a more accurate estimate of value.
TORISON
The medical term for involuntary movement of the testes is "testicular torsion." This condition occurs when the spermatic cord becomes twisted, cutting off blood flow to the testicle, resulting in severe pain and swelling. Testicular torsion is a medical emergency that requires prompt treatment to prevent permanent damage to the testicle.
Torsion
Hollow members are more efficient than solid with equal area
Torsion means twisting or being twisted. Intestinal torsion can be fatal.
Vehicle does not have torsion bars
Instead of using coil springs on the front suspension torsion bars are used from the lower control arms to the frame ( my 1995 Ford Explorer 4x4 has torsion bars , my dads 73 Dodge Coronet had torsion bars ) If you look at a lower front suspension that has torsion bars you will see the torsion bars going from the lower control arms rearward
Spraining your ankle is typically caused by a torsion force, which is a twisting force that causes the ligaments in the ankle to stretch or tear.
I'm pretty sure that only 4WD trucks have torsion bars.
A Dodge Ram does not have torsion bars.
The tundra does not have torsion bars, buy a lift.
A 2WD Tahoe does not have torsion adjustment bolts, it uses front coil springs and not torsion bars.
The 1st generation Nissan Pathfinder, 1987 - 1995 had a torsion bar suspension on the front end of the vehicle. There is a driver's side and passenger's side torsion bar and they are not interchangeable. 1996 - 2009 models do not use a torsion bar.
There is a bolt near rear of torsion bar (the end closer to rear bumper) which will increase or decrease the tension on torsion bar when you adjust bolt.