By inventing something one creates something that wasn't and creates something that is. Amperage was always there, and various people characterized what was meant by current and how it manifested itself under certain circumstances. For example, in a lightening strike there is a lot of current flowing through the air. Imagine Ben Franklin flying his kite in a storm. He was trying to see how one could harness the power of electricity.
For more info research the following individuals:
André Ampère (1775-1836)
Alessandro Volta (1745-1827)
Georg Simon Ohm (1787-1854)
Ernest Rutherford (1871-1937)
Benjamin Franklin (1706-1790)
Thomas Alva Edison (1847-1931)
Michael Faraday (1791-1867)
Nicholas Tesla (1856 - 1943)
To calculate the amperage, you need to know the resistance in the circuit. Amperage is calculated using Ohm's Law: Amperage (A) = Voltage (V) / Resistance (R). Without knowing the resistance, we cannot determine the amperage.
To calculate the amperage, you can use the formula: Amperage = Watts / Volts. Thus, for 10,000 watts at 240 volts, the amperage would be 41.67 Amps.
Voltage is equal to amperage time resistance. V=IR Therefore, I'd say voltage times amperage is equal to amperage squared times resistance. VI=IIR Really there's no point in multiplying the two. However, if you were to divide voltage by amperage, you would have the resistance of the circuit. V/I=R
The amount of amperage needed for a 220V well will depend on the wattage of the well pump. To calculate the amperage, divide the wattage of the pump by the voltage (220V) to get the amperage required.
The 225 amps is the secondary output amperage. Look on the machines nameplate to find the input amperage. It is that amperage that is needed to size the feed wire and there the breaker size. When you find that amperage you may want to re question the breaker size.
Amperage is electric current of flow.
It is ok to use a fuse with a higher amperage rating and not ok to use a fuse with a smaller amperage rating why?
This doesn't make sense, "current" is "amperage" so the higher the voltage the lower the amperage, and the lower the voltage the higher the amperage.
There is no proper amperage...no such thing as amperage, its called current... measured in amps...
Wire size is based on the amperage drawn. To find the amperage, the voltage must be stated. Use this formula to find the amperage. I = W/E. Amps = Watts/ Volts. Once you have the amperage, restate your question using the new found amperage or state the voltage that supplies the lights.
An amperage is the electric current's strength carried by a conductor or machine generated as measured in amperes.
a ten-wrap amperage multiplier is used with a (n)
How much amperage for a hotpoint 20 inch stove
The recommended amperage for a dryer outlet is typically 30 amps.
The required amperage for a stove typically ranges from 40 to 50 amps.
The standard amperage for a typical outlet is 15 or 20 amps.
The standard amperage requirement for a stove is typically 40 amps.