answersLogoWhite

0

What else can I help you with?

Continue Learning about Natural Sciences

Use of erlenmeyer flask?

Physical DescriptionAn Erlenmyer Flask (named after Emil Erlennmeyer) is a common piece of laboratory glassware since 1861. It is also known as as a conical flask or E-flask. It has a conical body, flat base and a narrow cylindrical neck. The flask is usually marked to indicate the approximate volume of their contents.The flask is chosen to replace a beaker if there is a need to stopper the contents. The narrow neck is sized to accept standard rubber stoppers or corks.The conical shape and narrow neck facilitates stirring by swirling.The small neck reduces evaporates losses. The neck may be fitted with side tubes to allow the extraction of produced gasesThe flat bottom improves stability on lab benches. A Florence flask has a similar overall use but is more unstable because the body is round and the base is smaller.UsesErlenmeyer flasks are used for:pH tit rationsthe preparation of mixtures which must be mixed without Starr


How does chromatography check the purity of a substance?

you put the blob off a blob off the substance you want to test on to a piece of chromotography paper about 10mm from the bottom then fill a flask about 20mm and let the bottom of the paper sit in the water if the substance is pure then there will only be one colour goes up the paper.


How would you wrap a piece of paper around a cylinder whose base diameter is smaller than its top diameter keeping the paper flush against the cylinder?

To wrap a piece of paper around a cylinder with a base diameter smaller than its top diameter and keep the paper flush against the cylinder, you can make a slit along one side of the paper from the edge to the center. Then, overlap the edges of the cut and tape or glue them to create a conical shape that matches the slant of the cylinder. This will allow you to wrap the paper smoothly around the cylinder.


Which piece of glassware is bigger flask or cylinder?

Typically, a cylinder is larger than a flask in terms of volume capacity. However, the actual size can vary depending on the specific dimensions of the glassware.


Is cutting paper change in shape?

Take a piece of paper and cut it in half (anywhere will do) and you will have two pieces of paper - and your original piece of paper has changed shape.

Related Questions

Why was the conical flask placed on a white piece of paper in titration?

The white paper helps to provide a clear background for observing color changes during the titration process. This is important for accurately determining the endpoint of the titration when the color changes indicate the completion of the reaction.


What is a comical flask?

A comical flask is a humorous or novelty version of a regular flask used for carrying and storing liquids. It often features quirky designs, funny quotes, or amusing graphics to make it a fun conversation piece.


What is 1 piece of equipment a scientist might use?

pipette, bath, bunsen burner, conical flask, thermometer, u.i soln.


What is Erlenmeyer flask and its uses?

Erlenmeyer flask is a conical flask made from glass or plastic, sometimes graduated or with a stopcock; uses: - to contain liquids or powders - to realize chemical reactions - it is the preferred flask for titration - heating of liquids (only in Pyrex glass) See also the link below.


How do you prepare a cotton plug for conical flask?

To prepare a cotton plug for a conical flask, take a small piece of cotton wool and roll it between your fingers to create a plug. Ensure that the plug is slightly larger than the opening of the flask so that it fits snugly when inserted. Wet the cotton plug with distilled water or the appropriate solution to help it stay in place and create a seal.


Why the conical flask placed on a piece of white paper in titration?

Erlenmeyer Flasks are graduated, meaning they have calibrated lines to help detect the level the solution reaches, much like a graduated cylinder does. Knowing the relative level is important during titrations because they are usually done over many many times and its good to know when the change will take place approximately. But then again burrettes also have calibrated line which are much more accurate. Basically I think it boils down to the idea that a flat bottomed flask is less likely to tip over than a round bottomed, volumetric one. So why not just use a beaker? Well probably to avoid from any solution bouncing out as the drops fall into the solvent. A beaker just has a much larger opening at the top. Regardless though, its convention in the chemistry community.


Use of erlenmeyer flask?

Physical DescriptionAn Erlenmyer Flask (named after Emil Erlennmeyer) is a common piece of laboratory glassware since 1861. It is also known as as a conical flask or E-flask. It has a conical body, flat base and a narrow cylindrical neck. The flask is usually marked to indicate the approximate volume of their contents.The flask is chosen to replace a beaker if there is a need to stopper the contents. The narrow neck is sized to accept standard rubber stoppers or corks.The conical shape and narrow neck facilitates stirring by swirling.The small neck reduces evaporates losses. The neck may be fitted with side tubes to allow the extraction of produced gasesThe flat bottom improves stability on lab benches. A Florence flask has a similar overall use but is more unstable because the body is round and the base is smaller.UsesErlenmeyer flasks are used for:pH tit rationsthe preparation of mixtures which must be mixed without Starr


What happens i a potato placed in a unprinted paper put in oven?

If you place a potato on an piece of unprinted paper in the microwave oven, the potato would heat up, the paper would not.


A small round conical piece of lead fired from a firearm?

A bullet


What is the use and definition of an Erlenmeyer flask?

The triangular shape of the Erlenmeyer flask aids in the mixing of the liquid inside. When you swirl the flask, the liquid moves up the sides without coming out the top. They are used in applications where solutions must be mixed multiple times. When doing a titration analysis, small amounts of reactant are added to a solution, usually until an indicator changes color, and the solution must be mixed after every addition. When making a dilution of a stock solution, the easiest way is to add a measured amount of stock to a measured amount of solvent in an Erlenmeyer and swirl to ensure thorough mixing. Erlenmeyer flasks are often used to heat liquids with a Bunsen burner. For that purpose, the flask is usually placed on a ring held to a ring stand by means of a ring clamp. A wire gauze mesh or pad is usually placed between the ring and the flask.


What is the plural of a piece of paper?

The plural of a piece of paper is "pieces of paper."


How does chromatography check the purity of a substance?

you put the blob off a blob off the substance you want to test on to a piece of chromotography paper about 10mm from the bottom then fill a flask about 20mm and let the bottom of the paper sit in the water if the substance is pure then there will only be one colour goes up the paper.