Different components draw different currents because they have varying resistance values. Ohm's Law states that current is directly proportional to voltage and inversely proportional to resistance. Therefore, components with higher resistance will draw less current, while components with lower resistance will draw more current for the same voltage.
Equator
The sum of currents in a circuit is known as total current, which is the combined flow of all individual currents passing through the circuit components. This total current is conserved in a series circuit where it remains constant throughout the circuit.
Deep ocean currents and surface currents do interact and influence each other. While they flow at different depths and have different driving factors (wind for surface currents and density for deep currents), they are connected through the global ocean circulation system. Changes in one can impact the other over time.
Symmetrical components are a good way to represent out-of balance currents in 3-phase power supplies. In general an unbalanced set of currents in a 3-phase system can be represented by three compents, which are an in-sequence component, an out-of-sequence (rotating oppositely) component, and a zero-sequence component. At a high-power substation there would be meters for all three components of the current. When the currents are perfectly balanced only the positive sequence current would be non-zero.
Surface currents are created by air currents, earth's rotation, and positions of the continents.
They are both currents nut have different locations or spots they are from.
A parallel circuit has different paths for current to flow. In a parallel circuit, the components are connected side by side, allowing current to flow through multiple paths simultaneously. This results in different currents flowing through each path based on the resistance of the components.
surface currents
In the circuit shown, there are potentially three different currents.
fimbriae
The ocean currents are colder than the currents in the mantle,and the are located in different areas.
Electricity is the interaction of many components. These include electric charges, electric fields, electric potentials, electric currents, and electromagnets.
Electricity is the interaction of many components. These include electric charges, electric fields, electric potentials, electric currents, and electromagnets.
The current is reversed from the morning's cycle
Generally speaking, the stroke order is left to right, then top to bottom. However, different strokes have different directions and some Kanjis are made of combinations of other Kanjis or components, in these cases it is best to know which order to draw the components/kanjis in to complete the entire kanji.
SURFACE
since both coils will have resistance, yes; but the load will be the primary amp draw