Because you are generally sitting down with your feet off the floor or ground when you are swinging your legs, and your legs just naturally bend at the knees when you are sitting down. It is impossible to swing your legs back and forth standing on your feet.
Friction of the material at an atomic level.
You can't.
On each side of new receptacle there is a tab between the screws that hold the wires. This tab is bent back and forth until it breaks off. (Usually on the Brass or hot side.) The receptacle is now split and can now be wired for two separate circuits or one outlet switched and the other not. Easy way is to strip the wire under 1 screw back till it will go under the other screw on the same side and tighten.
OF2 has a bent shape.
volatile
Friction of the material at an atomic level.
Copper is malleable, it can be bent and it will not break, but bending it back and forth too much may break it.
The road bent back and forth; it was very curvy. My girlfriend is a beautiful woman; she is curvy.
Bad wheel bearing? Bent wheel? Bad tire? Bent axle? cv joint. very extremely unbalanced tires, manys things
Aerodynamics and they make it easier for racers to tuck.
your a hunchback now go back to Notre Dame
obtuse
The bassoon.
To fix a bent auger on a snowthrower try to bend it back in place. Use a hammer and slowly and gently tap it back to its original shape.
Swing your arm right round from your sholder, start with youre arm bent, then thrust as hard as you can, release the ball when youre arm has gone past youre leg and continue to swing youre arm round
A mineral that can be bent without breaking and will stay bent is said to be malleable. This is one of the main properties of metals.
yes.You can either buy them unbent and bend it yourself or just buy them pre-bent