0
A flow rate value greater than 1.00 indicates that the amount of material passing through a certain point is more than the total available amount, which is not physically possible. It suggests a miscalculation or error in measurement, as the flow rate should always be within the constraints of the system's capacity.
What else can I help you with?
Why the value of coefficient of contraction is greater then the theoratical value in experiment?
The coefficient of contraction in an experiment may be greater than the theoretical value due to factors such as flow imperfections, wall roughness, or turbulence in the flow. These factors can lead to additional energy losses and create a greater contraction in the flow compared to the ideal theoretical case. Experimental conditions and inaccuracies in measurements can also contribute to discrepancies between the observed and theoretical values of the coefficient of contraction.
What happens to a fuse when the flow of charges stop?
Current i.e.rate of flow of charge when stops flowing in a circuit then fuse does not blows out. The only work of fuse is to blow away when the current starts flowing greater in magnitude than the rated current value.
Is pressure loss larger in liquid flow or gas-liquid flow?
Pressure loss is typically larger in gas-liquid flow compared to liquid flow due to the compressibility of gas. Gas-liquid flow can experience significant pressure drops due to the expansion and compression of gas bubbles within the liquid, leading to greater friction losses.
Substance whose molecules have greater freedom of movement enabling them to flow?
A substance with molecules that have greater freedom of movement enabling them to flow is considered a liquid. In liquids, the molecules have enough energy to move past each other but still remain relatively close together. This allows the substance to take the shape of its container.
According to if it were not for pulmonary surfactants you should expect the surface tension in a small alveolus to produce greater pressure than in a large one and air would flow from small to large?
Pulmonary surfactants reduce surface tension in alveoli, preventing them from collapsing and making it easier for air to flow in and out of the lungs. Without surfactants, smaller alveoli would have a higher surface tension, leading to greater pressure inside them compared to larger alveoli. As a result, air would tend to flow from smaller alveoli to larger ones to equalize pressure, potentially causing problems with lung function.
Why the value of coefficient of contraction is greater then the theoratical value in experiment?
The coefficient of contraction in an experiment may be greater than the theoretical value due to factors such as flow imperfections, wall roughness, or turbulence in the flow. These factors can lead to additional energy losses and create a greater contraction in the flow compared to the ideal theoretical case. Experimental conditions and inaccuracies in measurements can also contribute to discrepancies between the observed and theoretical values of the coefficient of contraction.
Is the R-value of insulation indicate resistance to heat flow?
Yes, the R-value of insulation indicates its resistance to heat flow. The higher the R-value, the greater the insulation's ability to resist heat transfer, making it more effective at insulating a building.
The insulation that is most resistant to heat flow is rated?
It depends on the application. Ceramics are probably the best without specifics. Fiberglass and aluminum foils are also very good it certain situations.
What way would cash flows differ in different countries?
The cash flow is different in different countries because of the econmoy. Depending the value of the currency some countries would greater cash flow compare to poor countries.
Is cleaning a mass air flow sensor often successful in eliminating the cars symptoms?
That is a NO NO. You should never clean the mass air flow sensor it will mess it up.
What is the difference in heat loss between r30 and r38?
The higher the R-value, the better the insulation. Therefore, a material with an R38 insulation value will have less heat loss compared to a material with an R30 insulation value since it provides greater resistance to heat flow.
How do you code the program using arithmetic exceptions?
Never.A program should handle exceptions, but should NEVER USE exceptions to control program flow.
What happens when leakages are greater than injections?
if leakages are greater than injection the circular flow will be in disequilibrium because more money is leaving the circular flow
Does the permeability to water affect the equilibrium flow in and flow out value?
no
What happens to a fuse when the flow of charges stop?
Current i.e.rate of flow of charge when stops flowing in a circuit then fuse does not blows out. The only work of fuse is to blow away when the current starts flowing greater in magnitude than the rated current value.
What is the relationship between the present value and time?
The relationship between present value (PV) and time is inverse; as time increases, the present value of a future cash flow decreases. This is due to the concept of time value of money, which states that a dollar today is worth more than a dollar in the future because of its potential earning capacity. Therefore, the longer the time until the cash flow is received, the greater the discounting effect, leading to a lower present value.
The r value of insulation indicate resistance to heat flow?
yes the R-value does indicate resistance to heat flow
