Defective clock or it is wired incorrectly. Should be wired to have power when ignition is turned off. it sounds to me that the constant live has been lost to the clock, there are three wires to a vehicle clock, an earth, an ignition live and a constant live
To change the clock in a 2009 Altima, first turn the ignition to the accessory position without starting the car. Then press and hold the "Clock" button until the time display starts blinking. Use the "Seek/Track" buttons to adjust the hours and minutes, then press the "Clock" button again to save the new time.
It is a physical change
Yes, that's correct. When the clock is turned back for daylight saving time, you gain an extra hour of sleep as the time is adjusted backwards by one hour. This change occurs at 2:00 am on the first Sunday in November in the Pacific Standard Time zone.
A 2003 what?
To change the time on a Primex wireless clock, locate the "Set" button on the clock and press it. Enter the current time using the keypad provided and press "Enter" once done. The clock should now display the updated time.
To reset the oil change light, hold down the odometer and clock buttons for a few seconds. (with the ignition turned on).
The hot wire bypasses the ignition.
the Clock is probably wired to the ignition and power is turned off every time you turn off the Car there fore you have to reset the clock.
To set the clock in a Mercury Villager van, first turn the ignition key to the "On" position without starting the engine. Then, locate the clock adjustment buttons, usually found on the dashboard near the clock display. Press the "Hour" button to set the hour and the "Minute" button to set the minutes. Once set, the clock will retain the time after the ignition is turned off.
To change the clock in a Peugeot 106, first, turn on the ignition without starting the engine. Locate the clock adjustment buttons on the dashboard, usually found near the radio. Press the "H" button to adjust the hour and the "M" button for the minutes. Once set, the time will automatically save when you turn off the ignition.
To change the clock in a 2005 Kia Spectra, first, turn on the ignition without starting the engine. Press and hold the "Clock" or "Set" button on the stereo until the clock display starts blinking. Use the "Tune" or "Seek" buttons to adjust the hours and minutes, then press the "Clock" or "Set" button again to save the changes. Finally, ensure the time is displaying correctly before turning off the ignition.
To change the ignition lock cylinder in a 2001 Chevrolet Tracker, first disarm the air bag system. Then remove the clock spring assembly to be able to remove the old ignition lock cylinder and replace with a new.
To change the clock on a 2002 Skoda Fabia, first, turn on the ignition without starting the engine. Then, locate the clock adjustment buttons on the dashboard, typically labeled with a "+" and "−" or "H" for hours and "M" for minutes. Press the "+" button to increase the hour or "M" button to adjust the minutes until the correct time is displayed. Once set, turn off the ignition to save the changes.
the memory wire is either not hooked up or is connected to a keyed hot that only has power when the ignition switch is on
This information can be found in your owner's manual. Turn ignition on and rotate the spindle under the clock- clockwise for minutes and anti-clockwise for hours. Hope this helps.
To change the clock in a 2007 Mercedes ML 350, first, turn on the ignition without starting the engine. Then, locate the "Clock" button on the center console or the audio system. Press the "Clock" button, and use the tuning knob to adjust the hours and minutes. Once set, press the "Clock" button again to save the changes.
Turn your car on, so that the radio can be turned on and off. Then turn your radio off. After is it off, push the clock button and while holding clock, use seek to change the hour and tune to change the minutes.