answersLogoWhite

0

The homophone for "to cover with paper" is "wrack." The homophone for "a sharp blow or knock" is "rap."

User Avatar

AnswerBot

1y ago

What else can I help you with?

Related Questions

What is a homonym for a sharp knock?

A homonym for a sharp knock could be "nock," which is the groove at the end of an arrow where it rests on the bowstring. Homonyms are words that are spelled and pronounced the same but have different meanings. In this case, "knock" and "nock" are homonyms because they sound alike but refer to different things.


What is the homophone for a-sharp?

A sharp doesn't have a homophone. On a keyboard, it is synonymous with b flat.


How do you change the paper on Sharp EL-1801V?

To change the paper on the Sharp EL-1801V calculator, simply lift up the printer cover, remove the empty paper roll, insert a new paper roll with the end feeding from the bottom, and close the printer cover. Make sure to tear off any excess paper if needed.


What is a 3 letter word for sharp knock?

rap


What is an homophone for all?

An awl is a sharp, pointed tool.


What does the Hindi word knock mean in English?

Knock in Hindi means Sharp point of something, Like a Knife's, a pen's or a pencil's


How do you use knock as a noun?

The knock on the door was very loud


Does a sharp go up or down?

A sharp, the tone goes UP. In a flat, the tone lowers. A way to remember is, a sharp has sharp corners (#) and if you sat on it, it would make you go UP. Flats (b)...knock you DOWN (lower).


How do you get a paper cut?

when the sharp edge of paper hits your skin at the perfect angle, it cuts you


What inexpensive item should you use to cover a sharp razor while traveling?

A simple and inexpensive item to cover a sharp razor while traveling is a binder clip.


How can I effectively cover particle board with contact paper to enhance its appearance and durability?

To effectively cover particle board with contact paper for enhanced appearance and durability, first clean the surface thoroughly. Measure and cut the contact paper to fit the board, leaving a slight overlap. Carefully apply the contact paper, smoothing out any air bubbles or wrinkles. Use a squeegee or credit card to press out any bubbles. Trim any excess paper with a sharp knife for a clean finish.


Briefly explain how the grit on garnet paper maintains sharp edges?

The grit on garnet paper is made up of sharp, angular particles that scratch and abrade the material being sanded. As the paper is used, these sharp edges break down and expose fresh cutting edges, maintaining its abrasive effectiveness.