RSM9 is a zoning designation typically found in municipal planning that indicates "Residential Small Lot" zoning, which allows for the development of smaller residential lots. This zoning category generally aims to promote higher density housing while maintaining a residential character, enabling a mix of single-family homes, townhouses, or small multi-family units. The specific regulations, such as minimum lot sizes and building heights, can vary by municipality, so it's essential to consult local zoning codes for detailed requirements.
It depends on the zoning of the area your business is in.
check with your local zoning office but C2 is typically "Commerical" use property.
Residential in type/use. 2 units per lot maximum.
The property is in escrow or sold.
WDR1B is the zoning designation for residential single family or two-unit low density housing in West Hollywood, California. See the zoning map at the related link.WDR1B is the zoning designation for residential single family or two-unit low density housing in West Hollywood, California. See the zoning map at the related link.WDR1B is the zoning designation for residential single family or two-unit low density housing in West Hollywood, California. See the zoning map at the related link.WDR1B is the zoning designation for residential single family or two-unit low density housing in West Hollywood, California. See the zoning map at the related link.
RSM9 zoning typically refers to a residential zoning category that allows for medium-density single-family homes, townhouses, or multifamily structures on lots with a minimum size of 9,000 square feet. This zoning designation is intended to support a mix of housing types within a community while maintaining a residential character. Specific regulations may vary based on the local jurisdiction.
what is the definition of R1C zoning
If the locality's Zoning Board permits it. You have to talk to the zoning board (or zoning commission) where the property is located.
It depends on the setback requirements in the property's zoning. If it's zoned, the zoning regulations will state how close any part of the building can be to the property.
R-3 zoning typically allows for medium-density residential development, such as townhouses or apartment buildings. It may also permit some commercial or mixed-use developments in certain areas. Specific regulations and requirements will vary depending on the local zoning codes.
You have to follow county zoning laws and each zoning may very. Call your town hall.
It depends on the zoning of the area your business is in.
ZONING
That would be determined by the zoning laws and building codes in the community in which the property is located.
I'm going to give the economic tilt of this, then recategorize it into property law where they can probably give you some more practical answers. Basically in economics, if property has any limitations attached to it (zoning usually limits what the property can be used for), the property has a lower value. There are a LOT of exceptions to this (imagine a factory in the middle of a farm or subdivision), but that is the general rule. Zoning will limit what the owner can do with their property. For instance, a residential zoned property can only have housing built on it. That means that the owner could not build a place of business if they wanted to.
This depends on the zoning laws in your jurisdiction. If your property is zoned residential, you probably can, but I am not a lawyer and this is not legal advice.
That issue would be governed locally. You need to inquire at the local building and zoning departments.