answersLogoWhite

0

Doppler RADAR measures the speed of objects using the Doppler effect (discovered by the Austrian mathematician and physicist Christian Andreas Doppler in 1842 at the Prague Polytechnic) in addition to the position measured by ordinary RADAR.

The earliest version of Doppler RADAR was introduced by the U.S. Navy during WW2 on night fighters.

Doppler RADARs are used now in aviation, sounding satellites, meteorology, police speed guns, radiology and healthcare (fall detection and risk assessment, nursing or clinic purpose), and bistatic radar (surface-to-air missile).

User Avatar

Wiki User

9y ago

What else can I help you with?

Continue Learning about Other Engineering

What is ground penetrating radar used for?

Ground penetrating radar (GPR) is a geophysical method that uses radar pulses to image the subsurface. When the waves hit an object, the receiving antenna can be used to distinguish what it is. This can be used to find precious metals, like gold, underground.


How low do you have to fly to fly under radar?

It depends. Flying below radar is usually flying below the equipment used to detect things on radar. It could be a very high tower, hundreds of stories off of the ground, or it could be a satellite just a couple stories off of the ground.


How do you make plane invisible to the radar?

It is not possible (with today's technology) to make a plane completely invisible, but there are techniques to reduce the radar energy being reflected to the radar aerial. If reduced enough, the aircraft may appear smaller than it is, or even be classified by the system or operator as a non-aircraft. The aim is to reduce the Radar Cross Sectional Area (RCA) of the plane.This technology is commonly referred to as 'stealth'. Modern stealth aircraft have an RCA much smaller than 1 square metre and in some circumstances can be as low as that of a large bird.The most noticeable method of reducing RCA is to eliminate right angles and especially internal angles of 90 degrees. This is because energy entering will be reflected straight back the way it came. By using curves and obtuse or acute angles the energy is instead reflected away from the radar source. Use of clean lines and unbroken surfaces also reduces bumps and protrusions which also increase the RCA. By comparing a modern stealth fighter to older aircraft, it is clear that care has been taken to eliminate any feature which would reflect radar energy.Another less obvious technique is to use radar absorbent paint. This expensive material works best against specific wavelengths of radar and will dramatically reduce the reflected energy. It works by allowing a proportion (about 50%) of the energy to be reflected and the remainder to penetrate. If the paint is exactly 1/4 of a wavelength think (hence the expense!) it will reflect off the inner paint surface and be 'antiphase' as it emerges again. This cancels out much of the radar energy in the same way that ripples in a pond from two pebbles cause patterns of high and low ripples.Combinations of techniques such as these can reduce the aircraft RCA to that below the capability of most radars to detect at normal range. As the aircraft approached the radar emitter the radar signal will be increased until it is recognisable as an aircraft. However, by avoiding flying close to radars it may be possible to avoid detection at all, or at the least until it is too late to be a problem for the mission.


How are echo soundings used by ships?

Ships use echo soundings to find object, ice bergs and other dangers to the ship wilst at see. Its like bats, the ship sends out a high pitched sound, and detects for echos. If it gets one, it will show up on the radar, and the shipd captain/navigator shall steer around it.


What is Graeme Addison known for?

Graeme Addison is a blogger and former professor and is best known for several books on South Africa's history of innovations.