0
A plenum is a space, usually an enlarged space in air handler ductwork (forced hot air heating systems). In the plenum the air can be heated, cooled, humidified or dehumidified before being redirected down smaller ducts for the final endusers. It is often the first space through which air, being drawn in through the filters, passes into the system.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
How do you find diameter of a shaft when bearing no is given?
How do you find dia meter of shaft when bearing no is given?
Where can you find a simple machine?
Almost everywhere!!!
Where can I find a copy of the Instructor's solutions manual to Systems engineering and analysis 4th ed By Benjamin S Blanchard Wolter J Fabrycky?
Hello, did you ever find the solution manual for this book? please email me wanted_os@hotmail.com
What compound machine has 3 or more simple machines in it?
All you have to do is fine a simple task to do and find simple machines and connect them together to make it. All you have to do is fine a simple task to do and find simple machines and connect them together to make it.
What are the formulas for simple machines?
the formulas for simple machines help find the ama, ima, and the efficency
Where is fuel pressure regulator on 1992 Chevy s10 v6 vortec?
Inside the intake Plentum. Remove top half of plentum. In the center on the passengers side.
What is the torque spec for 1988 2.8 liter gm plentum?
15 foot pounds
How much does it cost to replace plentum gasket on ford windstar 2002?
Which plenum-intake or. . . .
How do you change the intake manifold gasket on a 1998 park avenue?
What engine? and ensure it is a bad gasket, not an intake plentum.
Where is the fuel injector on a 1988 ford f150?
your fuel injector is under your plentum which goes over you valvecover to your trottle body.
Where is the Fuel Pressure Regulator on a 1996 Chevy Blazer V-6?
On a standard fuel injected 4.3l V-6 the regulator is located under the intake plentum next to the central fuel injector. If u have never had one of these engines apart it can be a little tricky, use caution when setting the plentum back on.
Where is located the temperature sending unit for a Isuzu rodeo 98?
Behind plentum almost against the fire wall about center of engine block
What does the intake manifold on a 1995 Oldsmobile Aurora look like?
Remove the plastic nuts on the gray cowl on the top of the engine. Notice the black plastic plentum, that's it.
Where is the PCV on a 1995 Pontiac Bonneville?
On a 98 it is in the plentum on the passenger side under the map sensor. turn the map sensor 90 degrees and pull straight up.pcv should be underneath.
What is the correct procedure to get at the EGR valve in a 1990 Corvette?
the only way i know of is to pull the upper plentum mabely with swivel sockets and luck you could pull one set of the intake runners
Where is the EGR valve on a 1991 Nissan 300zx?
Behind the plentum in the back of hte motor next to the firewall dead center. It looks like a pod with two pipes going in two differnet directions.
Are replaceing fuel injectors on a 1999 5.7 Suburban difficult for a non-mechanic?
i own a 99 Tahoe with the 5.7 i recently replaced head gaskets and the fuel injectors are not to bad to change with a little patience they are located under the plastic plentum that's bolted to the top of the intake dealing with the monster wiring harness is the worst part once you get the plentum off the injectors pop right out i would suggest a chilton manuel and a basic tool set and a hour or two should be all it takes.
