0
What else can I help you with?
Where might an acoustical engineer work?
Acoustical engineers are often employed as consultants to architects to advise on details of building elements: walls, floors, windows. In that capacity, they must be conversant in architectural as well as mechanical issues, since heating and air-conditioning (mechanical) equipment is often the source of noise that the architect may be concerned about. An acoustical consultant would be an essential member of a design team for an auditorium, sound stage or recording studio. Acoustical engineers are also employed in manufacturing situations, both as part of the design team to advise on how to design products for low noise (or better sound...) as well as in the capacity of hygienic professional to address hazardous noise areas of factories, etc.
What is orthogonal cutting?
The tool cutting edge is set at 90' to the direction of movement. The effectiveness of the tool depends greatly upon the slope of the active surface of the tool. The tool would tend to curl the chip in the form of a clock spring or a flat spiral. This is not the best form of chip for efficient metal removal. The disposal of such chips present difficulties, particularly in turning as the chip will stay on top of the tool holder and may damage the workpiece's surface.
What would happen to the filtration rate if you apply pressure to the filtration system?
It would increase
What do 3 slanted rocket fins do?
If they are all slanted in the same direction, I would think it would make the rocket spin as it heads toward it's destination. The same reason the blades on a fan are slanted, if they were flush, they would not push much air.
Where would you obtain the various documents that you will be using?
ocw.mit.edu
What Two reasons why a centre plate with a spring hub would be employed?
Give us the application.
State two reasons why a centre plate with a spring hub would be employed?
A centre plate with a spring hub is employed primarily to provide flexibility and accommodate misalignments between the driving and driven components, which helps to reduce wear and tear. Additionally, the spring hub allows for shock absorption, minimizing the impact of sudden loads or vibrations, thereby enhancing the overall durability and performance of the mechanical system.
Why would a centre plate with a spring hub be used?
A center plate with a spring hub is used to absorb shock and vibrations in a drivetrain system. The spring hub helps to dampen sudden loads or torque spikes, protecting the components from damage and ensuring smoother power delivery. This design can also improve drivability and reduce wear on the transmission components.
Why a centre plate with a spring hub would be employed?
1) This spring hub arrangement dampens torsional vibrations from the engine. 2) It also absorbs shock loads imposed on the drive line by sudden or violent clutch engagement. by akray
What are the components of the magazine body in the M9?
The magazine body is a component, and is one piece. The components of the complete magazine would be the magazine body, the floor plate, the spring, and the follower. US Navy Answer: Locking block plunger, Magazine spring, magazine tube, follower, floor plate.
What is the correct sentence employed at or employed with?
The correct sentence would be "employed at." For example, "She is employed at the bank."
What town is nearest the centre of the Australia continent?
Alice Springs is the city closest to the centre of Australia, but it is not one of the capital cities of Australia.
How do you find a list of people enlisted in the army and their rank between 1960 and1970?
You would have to be employed by the National Personnel Records Centre in St. Louis, and have access to all their records. No such list will be indexed and available otherwise.
How do you unjam a pistol magazine?
The best way to go about it is to remove the floor plate, then take out the spring and follower. If you're having misfeeds with that magazine, the most likely culprit would be either the follower, spring, or perhaps both, and it may be necessary to replace them.
What would cause a knock where the motor and trasmission meet 1995 Mazda b3000 5 speed?
cracked or warped flywheel Spring on the pressure plate could have come loose.
Would you personally be employed in a car manufacturing plant?
No, I would not.
Which physical would you measure with a spring scale?
You would measure weight.
