33
33%
5:9 ,i am not sure (;
Jacobian Ratio The Jacobian calculation is done at the integration points of elements commonly known as Gauss Point. At each intergration point, Jacobian Determinant is calculated, and the Jacobian ratio is found by the ratio of the maximum and minimum determinant value. The Jacobian Determinant of 2D elements is calculated after it has been projected on to a plane, and the determinant of 3D elements is found by direct calculation. If the quadrilateral element is not convex, the negative Jacobian ratio will be obtained, and elements with the negative Jacobian Ratio can not be solved with correct result.
12 is a single number. In so far as it can represent a ratio, it is a ratio of 12 to 1: a unit ratio.12 is a single number. In so far as it can represent a ratio, it is a ratio of 12 to 1: a unit ratio.12 is a single number. In so far as it can represent a ratio, it is a ratio of 12 to 1: a unit ratio.12 is a single number. In so far as it can represent a ratio, it is a ratio of 12 to 1: a unit ratio.
The ratio of all lengths is the same. The ratio of the circumferences = ratio of the radii = 2:3
33
33%
what is the maxiumum student to teacher ratio in kindergarten?
Deviation ratio: In a frequency modulation system, the ratio of the maximum frequency deviation of the carrier to the maximum modulating frequency of the system under specified conditions
The maximum loan-to-value ratio typically offered for a second mortgage is around 80.
it is ratio of maximum air to minium air
Both are the same. Just that the terminology differs from place to place. Floor Space Index is generally given in percentage whereas, Floor Area Ratio in numeric figures. Also, In Floor Space Index calculation, the total plot size is considered from the centre of the adjoining road(s). It is the effective plot area instead of total plot area.
Deviation ratio: In a frequency modulation system, the ratio of the maximum frequency deviation of the carrier to the maximum modulating frequency of the system under specified conditions
Turndown ratio refers to the width of the operational range of a device, and is defined as the ratio of the maximum capacity to minimum capacity. For example, a device with a maximum output of 10 units and a minimum output of 2 units has a turndown ratio of 5.
Its depends on location and type of towers. Supposed the transmission line is erected at hill area and second line is erected in desert area and third one in forest area. Then the allowable value of weight span and wind span ratio in transmission line will different. Also this ratio will depends on types of tower . Like the value is different in 132KV, 220KV , 400KV and 765KV.
The maximum student to teacher ratio in Florida is regulated by the senate. The maximum allowed number of students per teacher for grades preschool through 3rd grade is 18. The actual ratio will vary from school to school.
Slenderness Ratio is Basically a Ratio to decide if the Steel angle being used is acceptable for particular loads or not. There is no such allowable limit of slenderness ratio For a particular angle unless it is designed for a particular load. Slenderness Ratio indicates the buckling of the Steel angle. Less the Slenderness Ration more stronger is the Steel angle. I am an Engineer ( specialised in Towers for Transmission of High Voltages. In Our Case, we use three types of slenderness ratio . For Main Members it Should Be less Than 120 For Bracing etc it should be less than 150 and for redundant members( No load) < 200 Amit Sharma MottMacdonalds limited 00971501257201 amit.sharma@mottmac.co.ae