Try holding the trigger back when you remove the bolt
3 - Three
you can get that mount at mid way
Hi, depending on condition. should be around the $150.00 range.
Remove the stock and you will see what is keeping the bolt from sliding out.
Open the bolt, pull it to the rear, hold the trigger back and remove the bolt. sales@countrygunsmith.net
That will depend on your skill level, the type of ammunition used and the game being hunted.
. to remove the bolt on this model you must lower the tube assembly,there is a screw under the stock, remove stock first.
First remove the screw opposite the bolt. Operate the bolt as if you were cocking the gun, pull the trigger and it will slide out.
on the 22 model 121 to remove the bolt, open the bolt, pull the trigger and slide the bolt to the rear.
Remove the barreled receiver from the stock and then remove the screw from the left side of the receiver. The bolt will slide out.
Actuate the bolt to the rear and there is a tang in front of the trigger that hangs down..Press up on this tang and pull the bolt back and it will remove it from the action.
To remove the bolt from a Model 30A, first ensure the firearm is unloaded and pointed in a safe direction. Open the action and locate the bolt release, typically found on the right side of the receiver. Press the bolt release while simultaneously pulling the bolt handle to the rear until it clears the receiver. Once fully retracted, the bolt can be removed from the receiver.