0
What else can I help you with?
What is the difference in armoured and unarmoured cables?
Cables are two or more wires running side by side and bonded and there is armored and unarmored cable. Armored cables are protected by flexible steel covering while the unarmored cable is only covered by plastic.
The following fault should be found on flexible cords and cable with the exception of?
The fault that should not be found on flexible cords and cable is the ground fault.Faults that should not be found on flexible cords and cable is the ground fault.
How do cable companies get their TV signal?
Cable companies utilize satellite technology to initially get the signal, then it is distributed via underground or above ground cable.
What is a pylon in the national grid?
It's the large structure that holds the cable above ground.
What batterie cable is positive?
It should be RED, the Black is the Ground or Negative.
Where are armored cables and unarmored cables used?
Armored cable is used in environments such as a front yard where environmental conditions make an armored cable susceptible to damage. If the question is asking about Shielded/Screened cable, that has a small thin metal foil wrapping that is used to "screen out" most external signal noise from the cable.
What is the difference between sheathed and non-sheathed cable?
Cable sheath current is a current induced in the sheath by radio, magnetic or other interference, or a fault condition. The cable sheath should be grounded at one end so that this current flows to ground safely.
Why would there be 9.8 volts on ground cable when tested from ground cable to battery ground?
Something is shorted to ground.
What cable is the ground on a car bat?
The black cable is the negative or ground. The red cable is the hot or positive calbe.
What could cause an automatic S10 pickup to sometimes act as if the battery were dead when the ignition key is turned?
1) Check the battery cable connections. They should be clean & tight. 2) Check the connection at the starter. They should be clean & tight. A loose ground cable on the battery. Check ground cable on the starter.
How do you properly ground an electric fence?
You need to have a grounding rod made of galvanized steel that is driven straight into the ground until only half an inch of bar is remaining above ground. The ground rod should be at least 6 feet in length. Drier land areas normally require a longer grounding rod, or more of them, spaced 10 feet apart. The ground rods themselves should be placed in [an] area[s] that are naturally permanently moist to have any effect. Then you have to run a grounding cable that is attached to the ground rod along the bottom or top of the fence (can be the top wire or bottom wire) all the way to the fence charger. This cable needs to be attached to the ground rod by ground rod clamps That grounding cable should be attached to that fence charger in order for the fence to be properly grounded. Check out the following links on tips and instructions on how to properly ground an electric fence.
What is a bad ground cable?
In an electrical circuit, you'll have a charged circuit (the positive), and a ground circuit... a bad ground cable is a cable which is somehow not effectively completing the ground.. could be poor conductive material, a break or fray in the cable, an improper grounding point..
