0
What else can I help you with?
How do you replace the barrel on a Remington 22 rifle model Mohawk 10c?
Loosen the screw on the forearm push up on the screw and the barrel will pull out
How do you break down a ranger model 103-13?
If your Ranger is a bolt action 22, it is likely a Marlin Model 81 made for Sears, and wearing their brand name. Step 1- open the bolt, and check that there is NO ammunition in the rifle. Do that twice. Then open the bolt, depress and hold trigger, and slide bolt out of the rifle. Step 2- Remove the large screw on the underside of the stock. You can now lift the action from the stock. The inner magazine tube can be turned, and withdrawn from the outer magazine tube. STOP. Do not disassemble the rifle further.
Looking for front screw for trigger guard-Marlin 22 rifle-model 60 W?
gunpartscorp website.
Where can you get a stock screw for a Winchester Model 60A bolt action rifle?
Numrich gun parts corp.(E-gun parts.com).
How do you disassemble Winchester model 88 308 caliber rifle?
There is a screw underneath the barrel on the end of the frame, take out the screw, take out the mag, and open the bolt. Then just pull the frame off of the gun.
How do you get the bolt apart on a Cooey Model 600 22 caliber rifle?
. to remove the bolt on this model you must lower the tube assembly,there is a screw under the stock, remove stock first.
Where can i find the main machine screw that holds barrel to the wood frame for .22 cal rifle by coast to coast model 288n?
Your rifle was made by Savage for Coast to Coast Hardware, and is a Savage Model 87J. The screw is available from Numrich Gun Parts Corp (look up their website). It is part # 105500A, and sells for $2.35 plus shipping. They are in stock at this time. Good luck- shoot safe and shoot often.
What is the monitor mount screw size for this particular model?
The monitor mount screw size for this model is typically M4.
Is the fluid res cap on a 1994 Ford Ranger screw off or pop off?
If It is the factory res, then it should be screw off.
Will the screw driver lock pick work for a 98 ranger with power locks?
no
What is the difference between a 4 screw and 3 screw Model 29 Smith and Wesson?
The one screw basically.
How do you set throttle stop screw on198 ranger 2.3 5 spd?
To set the throttle stop screw on a 198 Ranger with a 2.3L engine and a 5-speed transmission, first locate the throttle stop screw on the throttle body. Start the engine and allow it to reach normal operating temperature. Adjust the screw to set the idle speed, typically around 750 RPM for this model, ensuring the throttle plate is fully closed when at rest. Finally, double-check the adjustment by re-measuring the idle speed and making any necessary fine-tuning.
