answersLogoWhite

0

In order to use the line out in the Fender Performer 650, you will need an amplifier. Connect the cable from the line out to the amplifier. Make sure that the amplifier is turned on.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

Will a v star 650 fender fit a v star 1100?

No, a fender from a Yamaha V Star 650 will not fit a V Star 1100. The two models have different frame designs, dimensions, and mounting points, making the fender incompatible. If you're looking to replace or modify a fender, it's best to use parts specifically designed for your model. Always consult with a parts specialist or mechanic for the best fit.


Purchased the Fender G-30 amplifier and can't use the line out is the amplifier defective?

There's no such thing as a Fender G30.


How do you remove front fender Yamaha v star 650 custom?

To remove the front fender from a Yamaha V Star 650 Custom, first, secure the motorcycle on a stable surface using a stand. Use a socket wrench to remove the bolts securing the fender to the fork legs, typically located on both sides. After removing the bolts, gently pull the fender away from the wheel and disconnect any wiring for lights if applicable. Ensure all parts are stored safely for reinstallation or future use.


What guitar did David Henrie use?

fender stratocaster fender telecaster (hes really into fender's) fender stratocaster fender telecaster (hes really into fender's)


You have a 1984 305 Chevy HO engine with 480 lift cam standard exhaust manifold and 650 Holley carb you would like to what intake to use?

The Edelbrock Performer and Performer RPM would be good choices. Also there are a couple Weiand dual plane intakes that would work well.


How do you use fender in a sentence?

'The fender on my car got smashed in the wreck I was in.'


What guitar does Tommy Joe Ratliff use?

He Uses A Fender (guitar) he is a self declared fender man


What amps did Eric Clapton use?

fender


How do you hang front fender on 1976 corvette?

The fender is glued on about 3 in. down on the side at top. bolts on at bottom and on the front bumper. To break the fender lose at the top and off of the inner fender well use a puddy knife and a lot of care. After you remove fender sand the bonding strips and trial fit the new fender in place. Clamp it in place and draw lines so you can install in the same place. Remove fender. Put bonding glue on the bonding strips and on the inner fender. Put the fender back in place using the lines that you drew to line it back up. Clamp in place. Bolt the bumper back to fender and at the bottom. Wipe excess bonding glue off the fender and top surround and wait to dry. Sand and prep for paint. It know where as easy as bolt off and on and paint. Its A lot of time and work. Hope this helps


What is the difference between a 1987 325I BMW convertible fender and a Sedan fender?

Hi the difference in the convertible to a sedan is the back of the convertible fender is longer and will not work. If you are looking to repair rot on the bottom of a fender you can use the last five inches of the sedan fender, no more.


How do you get rid of driver performer?

Use unlocker


I have Mountain bike with a suspension fork I use offroad and I am going to buy mud fenders for it should I buy a front fender or a downtube fender along with a rear fender?

A front fender will catch more crud than a downtube fender, but downtube fenders are easier to mount.