0
What else can I help you with?
How wind is captured in a wind turbines?
The wind is captured by the blades of the wind turbine, which are aerofoil shaped. The force drives the blades which are precisely angled by a computer system to make the most efficient use of the available wind. The rotating motion of the blades attached to the hub, drives a gearbox which increases the rotating speed from the hub. The output of the gearbox spins a 3 phase generator at high speed that is computer matched to the existing grid frequency, supplying it with power.
Why is 690 volts used as a wind generator?
400 volts 3 phase is the standard voltage in Europe, and wind generators originated in Europe. 3 phase induction motors are readily available and become induction generators when driven faster than there syncronous speed mechanicaly by an external force, like the wind in the case of wind generators. Motors are typically delta connected and have 400 volt windings. In the case of generators there is an efficiency gain by configuring the 400 volt windings in a star configuration because the higher voltage will yield a lower current allowing a smaller diameter conductor. Square root of three times 400 volts equals 690 volts. Viola!
3 things that can produce electricity?
Solar panels convert sunlight into electricity through the photovoltaic effect. Wind turbines generate electricity by converting the kinetic energy of the wind into rotational motion that drives a generator. Hydroelectric power plants produce electricity by harnessing the energy of flowing or falling water to turn turbines connected to generators.
How does wind energy change into other kind of energy?
1. First the kinetic energy makes the wind turbine move.2. Then the gearbox speeds up the moment while speeding up the 12 magnets inside the generator spins in the copper making electrons to move and that's electric energy.3. the electricity moves down the tower into a high voltage box.4. then goes to a power grid.5. the power lines lead to your house creating light energy.
What things are in the back of a wind turbine?
There are a few things on the backs of Wind Turbines: 1) Anemometers - wind speed sensors that help the turbine fine tune its blade pitch to be most efficient. 2) Wind Vanes - wind direction sensors that keep the turbine lined up with the wind, or turn it away from the wind when the gusts are too strong and can damage the turbine. 3) Visibility Lighting - red and white lights to meet requirements of aviation authorities for visibility.
Will a 208 volt 3 phase generator supply operate a 230 volt 3 phase motor?
Yes, but the motor's horsepower rating will not be reached.
Could works a 500 watts of power and 3 phases motor with a wind generator?
Yes, but it would have to be a pretty big and expensive wind generator. You would need an inverter to produce at least 500 watts of 3 phase power. Unless you also had some big batteries, you could only run your motor when the wind is blowing!
How to make a 3 volt garage remote work from a 12 volt battery?
Install a 3 volt battery and forget any modifications. It will not operate on 12 volts.
How do you connect a 4 wire us 240 volt generator outlet to a 3 wire Australian 240 volt 50Hz plug... Can an adaptor pigtail be made and how do you wire the pigtail?
Yes an adapter can be made. You must keep in mind that the US generator's speed is set for 60 Hz generation. The frequency of a generator is governed by the RPM of the engine. If the generator has speed control on it, it will have to be turned down so that the frequency meter reads 50 Hz.
What size wind generator to run 3 bed house?
A 5-15 kW wind turbine would typically be sufficient to power a 3-bedroom house, depending on the specific energy needs of the household and the average wind speed in the area. It's important to conduct a detailed energy audit to determine the appropriate size of the wind generator needed for your specific situation.
How do you make a 3 volt battery output 5 volts?
Add two 1 volt batteries in series with it.
How many output amps is a 75 KVA generator?
It depends upon the Generator system voltage. For 3 Phase, 600 Volt system, it will be 73 Amps For 3 Phase, 480 Volt system, it will be 90 Amps For 3 Phase, 208 Volt system, it will be 208 Amps
How do you get a 220 volt single phase from 380 volt 3phase synchrounos generator?
220 volt single phase from 480 volt 3 phase that one wire taken one phase and second wire connected in earth point. we get 220 v The above answer is incorrect, one phase from a three phase 480 volt system will give you 277 volts to ground. You must use a transformer to get the voltage you need.
What generator size is needed for 40 hp 480 volt 3 phase motor?
probably about 50 hp depending on how reliable the efficiency ratings of the various manufacturers are
Wiring diagram to convert a 3 phase 480 volt generator to 277 volt?
You should not need a wiring diagram. If the generator has a star point (wye) connection then the phase voltage to ground (star point) is 277 volts. 480/1.73 = 277.
Will 12 volt transformer work on 3 volt device?
No, it will destroy the 3 volt device.
3 prime energy sources that are generally used that drive an electromagnetic generator?
Wind, Hydro, Gas/Coal powered power station
