Absolutely ! I used to do that all the time when I was a CB operator. The only thing is - you must use an ATU to bring the SWR down to usable levels.
The maximum voltage allowed on a coaxial cable is typically around 60 volts. Exceeding this limit can cause damage to the cable and connected devices.
Waveguides are used at higher frequencies where their loss is lower than coaxial cable. Coaxial cable is used at lower frequencies where waveguides are too large and heavy. Lastly Coaxial cable is also used at higher frequencies where some flexibility is required.
Self-inductance in a coaxial cable is significant because it creates a magnetic field around the cable when current flows through it. This magnetic field can interfere with the transmission of signals by causing signal loss or distortion. To minimize this effect, coaxial cables are designed with specific spacing and materials to reduce self-inductance and improve signal transmission quality.
The resistance of the coaxial cable is determined by the resistivity of the material and the dimensions of the cable (length, inner radius, and outer radius). In this case, since the cylinders have zero resistance, the resistance of the coaxial cable would also be zero. This is an idealized scenario that does not take into account real-world factors such as imperfections in the material or connections.
The velocity factor for RG58U coaxial cable is typically around 0.66 to 0.70, which means that signals propagate through the cable at approximately 66% to 70% of the speed of light in a vacuum. This factor is important for determining signal propagation delay and matching impedance in RF systems.
I could be wrong, but I believe you are talking about an HDMI cable. Between the antenna and the TV set use RG6 cable.
A coaxial cable has great uses in television antenna connections. TV satellite connections also use coaxial cables to connect decoders to the TV set.
You can buy these products,but you could also rig one your self with an old antenna and some coaxial cable.
There are two types of cable used for television radio frequency signals: 300 ohm twin lead flat cable and 75 ohm coaxial cable. The twin lead is typically used with a rabbit ears antenna and coaxial is typically used with roof top antenna or cable TV setups.For television baseband video signals coaxial cables are usually used.However for digital television baseband video signals these are not adequate and special cables (e.g. HDMI, DVI, DisplayPort) are used. These cables are typically many twisted pairs in a common shield.answer is Coaxial cable
Coaxial cable, RG6u or RG 59u. The RG6u has less loss for longer cable runs.
Sometimes this will happen if you are using a coaxial cable on the antenna and there is a broken connector or even a cut in the cable somewhere.
The TV has video input in the forms of a coaxial (tv antenna/cable) and RGB inputs.
The cables that do that are HDMI, Displayport or coaxial cable (antenna) wires.
Uses of Coaxial Cable?
Coaxial one.
the center of coaxial cable drrrrrrrrrreinstein
how many wires does a coaxial cable have