at the very bottom of the ballon opposite where u tide it theres a part slightly darker poke something really sharp through it
A needle can pass through a balloon without popping it because the rubber of the balloon is stretchy and can temporarily seal around the needle, preventing air from escaping and causing the balloon to pop.
If you filled the bottle with water and then poked the balloon with a pin, I believe it would pierce but not pop it. With the balloon pierced, all you would then have to do is drain the water from the bottle, maneuver the balloon toward its mouth and drain it, and then finish removing the balloon either by fishing or dropping it out of the bottle's mouth.
...by pinching the balloon between your thumb and index finger and inserting the needle between the compressed rubber of the balloon at that point without letting go of the compressed balloon until you release the needle from the balloon.
To prick a balloon without popping it, you can use a needle or a sharp pin and gently insert it into the thickest part of the balloon where the rubber is most stretchy. Slowly push the needle through while holding the balloon tightly to release the air slowly, preventing it from popping.
To put a pin in a balloon without it popping, slowly insert the pin into the thickest part of the balloon where the rubber is strongest. Gently push the pin through rather than jabbing it in quickly to minimize the risk of popping.
yes
A needle can pass through a balloon without popping it because the rubber of the balloon is stretchy and can temporarily seal around the needle, preventing air from escaping and causing the balloon to pop.
If you filled the bottle with water and then poked the balloon with a pin, I believe it would pierce but not pop it. With the balloon pierced, all you would then have to do is drain the water from the bottle, maneuver the balloon toward its mouth and drain it, and then finish removing the balloon either by fishing or dropping it out of the bottle's mouth.
...by pinching the balloon between your thumb and index finger and inserting the needle between the compressed rubber of the balloon at that point without letting go of the compressed balloon until you release the needle from the balloon.
To prick a balloon without popping it, you can use a needle or a sharp pin and gently insert it into the thickest part of the balloon where the rubber is most stretchy. Slowly push the needle through while holding the balloon tightly to release the air slowly, preventing it from popping.
To put a pin in a balloon without it popping, slowly insert the pin into the thickest part of the balloon where the rubber is strongest. Gently push the pin through rather than jabbing it in quickly to minimize the risk of popping.
at the part where you blow it up Take a piece of tape and place it over the outside of the balloon. Poke the needle through the tape and through the surface of the balloon. The balloon will not pop because the surface of the balloon cannot expand, thus popping the balloon.
To burst a balloon without a popping sound, you can slowly release the air while applying increasing pressure on the balloon's surface. Alternatively, you can use a sharp object to create a small hole in the balloon and allow the air to escape gradually, avoiding a loud noise.
If you prick a balloon without water, the air inside the balloon will escape rapidly through the hole created by the prick. The balloon will quickly deflate and likely make a popping sound.
The distance a balloon can travel without popping will depend on various factors such as the material of the balloon, external conditions like temperature and altitude, and the initial inflation pressure. Generally, latex balloons can stretch to about 10-12 inches before popping, while Mylar balloons are more durable and can withstand greater elongation.
The 'popping' sound of a balloon disintegrating is made by the sudden expansion of air when the skin is damaged. The compressed air within is then able to escape. One interesting variant of your 'water' experiment, is to stick a bit of cellulose tape to the balloon, and then you'll find that you may puncture the balloon; through the tape; without it popping! It will eventually deflate however.
Yes ! :d