0
What else can I help you with?
What is the difference between noise and attenuation?
Noise (as related to a radio signal I suppose) is an unwanted signal being processed by a receiver. Attenuation is a loss of the intended signal before it gets to the receiver (usually due to such things as distance, line of sight obstructions, etc.
Is induced voltage and induced currrent the same?
Induced voltage is alsocalled ghost or phantom voltage as if you apply a load it vanishes. induced voltage will be potential/electrical pressure. Amperage is the actual flow of current being used, Watts being its calibration of total power used.
How do series circuits use current and voltage?
In a series circuit, the current remains constant throughout the circuit, as there is only one path for it to flow. The voltage is shared among the components in the circuit, with the total voltage being equal to the sum of the individual voltage drops across each component.
How does voltage affects the amount of energy that is transformed?
Voltage determines the rate at which energy is transferred in an electrical circuit. Higher voltage results in a faster rate of energy transfer, which can lead to more energy being transformed in a given period of time.
Why does needle seems undeflected when the range was 0-1000v?
When the range is set at 0-1000V on a voltmeter, the needle will appear undeflected because the actual voltage being measured is below the lower limit of the range (0V). The needle will only deflect when the voltage being measured falls within the selected range.
How many dB attenuation translates into 75 percent of voltage being lost to attenuation?
100 percent means full voltage or 0 dB.When 75 percent of the voltage is lost you still have 25 percent of the voltage.25 percent means damped to (-)12 dB.
What is the attenuation level of a twisted pair cable?
Attenuation occurs in all copper cable regardless of whether it is twisted or not. This is because the copper atoms actually 'resist" the electrical voltage being applied (a physics principle).
How Attenuation measured?
RMS Output divided by input, usually expressed in deciBells. Depends on whether it is power or voltage being attenuated. Voltage, it's 20log(Vout/Vin) Power, it's 10log(Pout/Pin) The difference is because power is proportional to voltage squared.
What is dampness?
Damping is the attenuation of vibrations or oscillations.
Why is beta radiation used to measure beta radiation?
Because its attenuation is proportional to thickness being penetrated
What term refers to a change in signal strength as a result of some of the electromagnetic energy being scattered reflected or diffracted after being issued by the transmitter?
fading also 'attenuation'
Does a repeater reduce the effects of attenuation for a digital transmission signal?
It depends on the repeater. Those that receive a signal, buffer it in real time and pass it on as a digital signal will reduce the effects of attenuation. Those that receive a signal and regenerate it with a new clock signal will generally eliminate the effects of attenuation completely.The type of repeater used depends on where and how it is used as well as the signal that is being transmitted.
What is limit of cable run between a secondary distribution center and a power distribution panel if wanting to keep voltage drop below 10 percent for the facility being energized?
150 feet
What is the difference between noise and attenuation?
Noise (as related to a radio signal I suppose) is an unwanted signal being processed by a receiver. Attenuation is a loss of the intended signal before it gets to the receiver (usually due to such things as distance, line of sight obstructions, etc.
What does the voltage on a digital multimeter indicate?
It generally reads RMS value of the voltage being measured
What does a vos tambien in English?
I believe it translates to 'to you too', with 'you' being plural.
What does gracias por ser como eres?
This translates to: "Thanks for being how you are."
