answersLogoWhite

0

Water lines should typically be installed 8-10 inches above the finished floor to allow for proper functioning of the sink. This height provides enough space for drainage and easy access for maintenance and repairs.

User Avatar

AnswerBot

1y ago

What else can I help you with?

Related Questions

What are the rough in measurements on a bathroom sink plumbing?

Your trap arm should be coming out from the wall at a height from the floor of 16-18", the cleanout just below the tee on the plumbing stack. The water lines should be at around 10-12 inches above the floor


How deep should drip irrigation lines be buried to ensure optimal water distribution and efficiency?

Drip irrigation lines should be buried about 6-12 inches deep to ensure optimal water distribution and efficiency.


Why does your faucet have 4 water lines going to it?

The other water lines are going to other fixtures. Your lines must be comming out of the floor for you to see the other lines. They are all teed together and only one line comming up to your faucet.


Where is the best place to run the electrical and water lines if your house has a cement floor?

Inside the walls.


How do you fix a leaking hot water line under the floor?

you should dig the floor.


Why do hot water lines freeze and cold water lines don't?

Cold water lines may have more insulation than hot water lines, otherwise they should both freeze unless there is some agent in the water.


How long should my shower curtain be?

The shower curtain should hang at least six inches below the edge of the tub to prevent water from spraying onto the floor. The curtain shouldn't hang too far into the tub or mold will develop on the curtain from trapped water.


What should you do after your wooden floor got soaked?

You should immediately try to mop up, or remove as much, if not all, of the water as you can. Leaving the water on the wood floor will cause it to warp out of shape.


How do you fix where the floor and wall meet that is where the water is coming in if I put stone and pipe in how far do I dig down?

You need to know the region's freezing depth. In southern Ontario it is 8 inches. Then you go down at least 12 inches to install the pipe. Be sure that as you excavate that no damage will be done to present lines which may be running.


How can you remove ground in dirt from a tile floor?

Mop the floor with hot water and soap (let it sit on the floor for about 15 minutes) . If the floor is really dirty you can buy a mild floor stripping product from your hardware store or you can rent a floor buffing machine. When the top dirt has been removed you can scrub the grout lines by hand with a green scrubbing pad with soap and water.


How often should flushing water lines be performed to maintain optimal water quality and system efficiency?

Water lines should be flushed regularly to maintain optimal water quality and system efficiency. It is recommended to flush water lines at least once a year to remove any buildup of sediment, minerals, or bacteria that can affect water quality and system performance.


Do you have a leak if your shower floor tile is hot?

Possibly, but the supply lines should be in the wall. Even on a slab house, the water should come into the house at the water heater and then be in the walls. Possible heat vent leak? I'm assuming a slab house because if there was access underneath, you would be able to tell if there was a leak.