Fiberglass is a strong material that can withstand pressure of up to 12,000 psi (pounds per square inch) before failure. This makes it suitable for a variety of applications where strength and durability are required.
424 kPa is 61.5 pounds per square inch (psi).
The full form of lbs in 15lbs pressure is pounds. It is a unit of measurement used to express force or weight.
5000 lbs of propane weighs 5000 lbs. Propane is a gas at room temperature and pressure, but is stored and transported as a liquid under pressure in its propane tanks.
The fiberglass cast that reaches from the toes up to just below the knee weighs one and a half pounds. This answer was from a very experienced nurse at the Hospital for Special Surgery who replaced my cast yesterday (1/13/2012). I asked because I was on a diet and needed to monitor my weight. She said she'd weighed several of them and that's about what they all weighed. My cast was made with a layer of stockinette, a layer of soft cotton padding, a layer of plain fiberglass tape, and an outer layer of decorative fiberglass tape. I'm 5' 10" and weigh 160 lbs.
77 lbs = 5.5 stone
it takes 76 lbs of pressure to collapse/crush one's windpipe
Depends Sometimes 10 lbs. and usually 50 lbs. sometimes up to 100 lbs.
for a mitshubishi gallant
Static or pressurized tank?
Conducted a lab at school measuring the strain on a soda can when it was opened. Back solving for the force as if the can were a thin walled pressure vessel led us to P = -54.447 +- 0.047288 Psi to 95% confidence.
A fiberglass topper for a full size truck weighs about 250 lbs.
150 lbs about the same as us
It looks like that on average, fiberglass ladders hold 225-300 lbs, while metal ladders hold 300-500 lbs, so if you need a lot of weight capacity, I would go with the metal ladder.
Hard hats are tested to withstand 40 ft lbs of impact which is equivalent to a 2lb hammer falling 20ft. -Occupational Safety and Health by David L. Goetsch
Mine weighs 3255 lbs with a VFN front end
The average is seven pounds.
Usually figure 10 lbs of pressure per 1000 rpm.