If the theft light is on in your vehicle, it usually means there is an issue with the anti-theft system. To turn it off, you may need to reset the system by locking and unlocking the car with the key fob or key. If this doesn't work, you may need to have the system diagnosed and repaired by a professional.
Giving off is emitting it and reflecting light is reflecting it
The light that bounces off of a surface is called reflected light. When light hits a surface, some of it is absorbed, and the remaining light waves bounce off in different directions, creating reflection.
When you turn off a flashlight, you break the electrical circuit that powers the light bulb. This stops the flow of electricity and causes the filament in the light bulb to stop glowing, thereby turning off the light.
Yes, flicking the light on and off fast does waste power. Turn the light on only when you need the light to see something in that room. Turn the light off when you leave the room to conserve power.
Reflected light.
When your Expedition is shut off and securely locked up , the theft light flashes to indicate the alarm system is armed
When the vehicle is shut off and locked up , the flashing theft light shows that the alarm system is armed
If the vehicle is locked , a flashing anti theft light means the security system is armed ( on )
no
This is just to deter theft. Whether or not your car came with an optional anti-theft system, the light will still be there, simulating a anti-theft system. It's just a light-emitting diode, so it doesn't have enough draw to drain the battery.
To reset the flashing theft light on a 2002 Ford Explorer, first, ensure that the vehicle is in the "Off" position. Then, insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the theft light turns off. Finally, turn the key back to the "Off" position and then start the vehicle to complete the reset.
It sould slowly flash when the engine is off.
To turn it off that's all you have to do is push down on the lcd light. It will light up different and that's how you know its off.
its always in theft mode. There should be a little light that will flash on the dash or around the speedometer when the ignition is off and the key is out.
Yes , once it's turned off and locked
After you lock the doors on your Explorer, the word THEFT will light uo in your gauge cluster for, I think it's 30 seconds, and then the word THEFT will flash on and off in your gauge cluster.
turn your key to the "on" position for 10 to 15 minutes until the anti theft light turns off. Once the light goes out turn the key to "off" for 5 seconds then start the car. It should reset the passlock sensor.