A lens with a negative focal length diverges light rays and creates virtual images, while a lens with a positive focal length converges light rays and forms real images.
can a magnitude of a vector has negative value?
No, convex lenses have positive focal lengths. The focal length is the distance from the lens to its focal point where light rays converge. In convex lenses, parallel light rays are focused to a point on the opposite side of the lens, resulting in a positive focal length.
A concave lens is called a negative lens because it causes light rays passing through it to diverge, or spread out. This is in contrast to a convex lens, which converges light rays and is called a positive lens. The negative or positive designation refers to the effect the lens has on the light rays.
Scalars can be negative, and so can a change in a scalar value.Take temperature:You can have a temperature of -10 degrees.If temperature falls from 20 to 5 degress, the change was -15 degree.The negative value of the scalar is a consequence of where you take the "zero" to be.With speed you have to be very careful because speed is the scalar bit of velocity. Velocity with no consideration of direction.
The longer leg of an LED is typically the positive (+) terminal, while the shorter leg is the negative (-) terminal. Additionally, the positive leg usually has a flat edge or a notch near it as a visual indicator.
positive
any any one positive or negative has to be grounded to reduce wire length , normally -ve is chosen as ground any any one positive or negative has to be grounded to reduce wire length , normally -ve is chosen as ground
No. The speed is the length of the velocity vector, and that is always zero or positive.
No. Measurement of length of rectangle sides is always a positive number in Euclidean geometry.
A number, negative or positive, does not have intercepts. It also does not have time, mass, length, width or political affiliation.
A calibrated focal length is an adjusted value of the equivalent focal length on a camera, so as to equalize the positive and negative values of distortion over a field.
L.E.D has one leg longer then the other one, the longer one is positive and the smaller one is negative. If you have a l.e.d which has same length of legs then look inside the l.e.d for two kind of triangle peices and one of them will be smaller which is positive and one which is bigger and is negative.
The length of the legs. The positive leg is always longer than the negative one.
not in the real world. The area of a square = The length of a side, squared. Any number squared is positive.
LOA stands for Law of Attraction, a concept that suggests positive or negative thoughts bring positive or negative experiences into a person's life. It implies that individuals can attract desired outcomes by focusing on them and maintaining a positive mindset.
can a magnitude of a vector has negative value?
Yes. There is no positive or negative rise to generate a slope, and it cannot have a run of zero length.