There can be aby number of psi in a cubic foot because psi is a measurement of pressure and the gas can be any pressure you care to make it.
26 millibars is equivalent to approximately 0.38 psi.
psi is an abbreviation of Per Square Inch
The gas pressure inside the cylinder is the force exerted by the gas on the walls of the cylinder. It is measured in units such as pounds per square inch (psi) or pascals (Pa).
2000 wog (Water, Oil, Gas) is a unit of pressure that does not directly convert to psi (pounds per square inch), as wog is not a recognized pressure unit. If you're looking to convert between units, you would need to provide the specific conversion factor for the material and its corresponding psi value.
There can be aby number of psi in a cubic foot because psi is a measurement of pressure and the gas can be any pressure you care to make it.
static 120 psi running 65 psi
26 millibars is equivalent to approximately 0.38 psi.
26 millibars = 0.377 psi
No more then a 1/2 PSI
about 2 PSI
10 cubic inches
The auto combustion pressure for a diesel engine is 580 psi. This is compared to the 200 psi of the gas powered engine.
we need the dimensions/volume of the tank not the psi (pounds per square inch) to answer that one.
According to Boyle's Law, the pressure of a gas is inversely proportional to its volume when temperature is held constant. If the volume of a container is halved, the pressure will double. Therefore, if the initial pressure is ( P ) psi, the new pressure will be ( 2P ) psi after halving the volume.
psi is an abbreviation of Per Square Inch
I think it is about 22 liters at 2400 psi equals one gallon of gas