A digital sensor, such as a digital thermometer or a digital scale, can send its measurements directly to a computer. These sensors use digital communication protocols such as USB or Bluetooth to transfer data to a computer for further analysis or processing.
Data is typically processed in the central processing unit (CPU) of the computer. The CPU receives instructions and data from the computer's memory, processes them using arithmetic and logic operations, and then sends the results back to the memory for storage or further processing.
No, the power steering pressure switch does not blow the fluid out. It simply monitors the pressure in the power steering system and sends a signal to the vehicle's computer. If excessive pressure is detected, it may trigger a warning light on the dashboard.
The light source, such as a bulb or LED, sends light through the microscope. This light is focused by lenses to illuminate the specimen being observed.
A car fob uses radio frequency signals to communicate with the vehicle's onboard computer system. When the fob's button is pressed, it sends a unique code to the car, which then verifies the code and unlocks the doors or starts the engine.
A light pen works by detecting light emitted by a computer monitor or screen when the pen's tip touches the surface. The pen has a light-sensitive photodiode at the tip, which detects the light and sends a signal back to the computer to identify the pen's position on the screen. This allows users to interact with software by pointing and selecting on the screen.
If the fax machine stores faxes itself and then puts them on your computer when you turn it on then no. However if the fax machine sends directly to your computer then yes it needs to be on.
A type of device that a computer sends information to.
Computer
A router is a computer component that gets an Internet signal from an outside source and sends it to a computer. It sends the signal to the computer through a cable or through a wireless antenna.
computer networking
http://support.microsoft.com/kb/923200 When the sending computer sends FIN, the state of the TCP connection is set to FIN_WAIT_2. After the TCP connection has been closed, the sending computer sends RST in order to reset the connection if the receiving computer sends any packets to the sending computer.
The source address contains the IP address of the computer (or other host) that sends the IP packet.The source address contains the IP address of the computer (or other host) that sends the IP packet.The source address contains the IP address of the computer (or other host) that sends the IP packet.The source address contains the IP address of the computer (or other host) that sends the IP packet.
Input as it sends the video/images into the computer.
transiver
It sends a signal directly to the satellite and the satellite pinpoints the location of it.
Ping