A setting is the part of a ring that holds a stone. There are different kinds: Bar, Channel, Pave, Prong, and Tiffany settings (a prong setting with six prongs), among others. A jeweler can show you more.
An invisible setting makes the diamond appear as if it is floating on the ring without any metal prongs or settings holding it in place. The diamonds are set flush against each other with no visible metal between them, giving the illusion of a continuous diamond surface. This results in a sleek and modern look that showcases the diamonds prominently.
"IKS" stamped on a ring typically stands for "Iolite, Kyanite, and Sapphire," which are gemstones that may be set in the ring. Iolite is a blue to violet gemstone, kyanite is a blue mineral, and sapphire is a precious gemstone known for its blue color. This stamp indicates the gemstones used in the ring setting.
The charge density of a ring is the amount of charge per unit length along the circumference of the ring. It is calculated by dividing the total charge on the ring by the circumference of the ring. Mathematically, the charge density () of a ring is given by the formula: Q / (2r), where Q is the total charge on the ring and r is the radius of the ring.
A small ring is commonly referred to as a "pinkie ring" when worn on the little finger of the hand.
The "D" on a piston ring typically indicates the cylinder bore diameter for which the ring is intended. The "N" refers to the ring's position on the piston, such as top, middle, or oil control ring. Together, "D N" specifies the ring's size and location within the engine.
The Setting For The Book Framed is at the school where the ring was stolen
Depending on the ring you will have to go to a jeweler, have him/her get an appropriate prong or bezel setting, have it soldered into the ring and then have your stone set into the setting. Don't forget to supply the correct size required as the ring will likely need to be cut to insert the setting and therefore will require resizing.
The stamp on the setting indicates the purity of the metal used in the setting, while the absence of a stamp on the ring itself may be due to the design, size constraints, or the method of manufacture. As long as the setting is stamped with the appropriate hallmark for sterling silver, you can be confident in the quality of the piece.
go to setting and ring phones and there should be a vibrating setting there!
Yes, you can get the the 1.15CT emerald and princess cut diamonds engagement ring with a platinum setting.
Well no not really. The cost of a diamond is usually independent of the cost of a diamond ring setting. The only relationship I can think of between these two values is when a diamond is fancy cut, has an unusual shape or is very large in size. In that case, a run of the mill ring setting may not do, and you may need to have your ring setting custom made in order to accommodate an unusual diamond.
Middle Earth
Founf a dimond ring that says 926 on it. What does it mean?
honestly i do not know!
Topaz is suitable for setting as a ring, pendant, or earrings.
I believe it means diamond setting
The onyx gemstone is not very expensive, so depending upon what metal is used for the setting and the ring, an onyx ring may not be expensive at all.