Serial ou seriado são pequenos episódios que se complementam, e séries são episódios extensos porém com o mesmo objetivo.
When resistors are connected in series, the total resistance is the sum of the individual resistances. When resistors are connected in parallel, the total resistance is less than the smallest individual resistance.
In a series connection, the current flows through each component in a single path, while in a parallel connection, the current splits and flows through multiple paths.
The phase difference between two waves is directly proportional to the path difference between them. The phase difference is a measure of how much the wave has shifted along its oscillation cycle, while the path difference is a measure of the spatial separation between two points where the waves are evaluated.
The DC voltage for the amplifier (transistor or FET) runs for a series-fed oscillator through the inductance of the LC circuit. A shunt-fed oscillator uses a radio-frequency choke or a resistor to deliver DC voltage to the amplifier. For an oscillator the difference between serial-fed and shunt-fed is small. The choke resonance frequency can interact with the LC circuit resonance frequency. This problem happens only with shunt-fed. Furthermore series-fed needs less components. Therefore it is prefered for (low power) oscillators. The output circuit of an amp can be series-fed or shunt-fed, too. The additional DC current through the coil will drive a iron or ferrite core earlier into saturation. This is an disadvantage of serial-fed. At a high-voltage tube RF amp with say 2000V DC voltage, in the shunt-fed amp only the choke and the DC blocking capacity have to withstand the high voltage. This is an advantage of the shunt-fed solution.
The equation for calculating the phase difference between two waves is: Phase Difference (2 / ) (x) Where: Phase Difference is the difference in phase between the two waves is the wavelength of the waves x is the difference in position between corresponding points on the waves
A tv series are scripts acted out for use on cable television only. A Series is scripts that have more than 1 "episode".
series and parallel are different types of circuits that a robot can contain
what is the difference between N series and C series in nokia mobile phones
difference between series is one pathway through circuit,difference between parralal is more then one pathway through circuit.
Expalain the difference between cyclical and seasonal variations in a data series?
16
telidu nana...
The difference between each number in an arithmetic series
The difference between the Lenovo T series and the Lenovo S series is the type of laptop. The Lenovo S series is a laptop, while the Levnovo T series is a tablet.
there are two (i think) differences. one is that in the serial number, the first letter is different. in 2004, it is E. in 2004A, it is F. The other difference is that the treasurer of the united states is different. in 2004, it is Marin, 2004A, is Cabral.
your name
Not much difference between them feature are almost similar