answersLogoWhite

0

Tapping the wire against the tube can disrupt any debris or material buildup on the wire, helping to clean it and potentially improve conductivity. It can also help dislodge any trapped air bubbles, enhancing the flow of liquid or gas through the tube.

User Avatar

AnswerBot

1y ago

What else can I help you with?

Continue Learning about Physics

What was the Edison Effect?

The Edison Effect is a fact about heated metal wire- discovered by a British scientist, Frederick Guthrie, in 1873, but named after Edison when the latter independently discovered it in 1880- that it will emit a current of negative charge into a vacuum, and the size of this current depends on the voltage across the metal wire. It states that a voltage across a wire results in a vacuum emission of current is the basis for the vacuum tube, an invention that Edison could have easily developed but decided not to pursue.


What is the effect of the magnetic field of a short wire on nearby objects?

The magnetic field of a short wire can attract or repel nearby objects that are sensitive to magnetic forces. This effect is stronger the closer the objects are to the wire and can cause them to move or align in a certain direction.


What is the relationship between the length of parallel wire inductance and its effect on the overall inductance value?

The length of parallel wire inductance is directly proportional to its effect on the overall inductance value. This means that as the length of the wire increases, the inductance value also increases.


What causes heating in wire?

Heating in wire is caused by the flow of current through the wire. The resistance in the wire causes energy to be converted into heat as the electrons move. This heating effect is known as Joule heating.


Why increasing the voltage applied to a wire can have the same effect on the current in the wire that decreasing the resistance of the wire does?

Increasing the voltage applied to a wire will increase the electric field, which in turn accelerates the charge carriers (usually electrons) in the wire, leading to an increase in current. Similarly, decreasing the resistance of the wire allows more current to flow for the same voltage applied, achieving a similar effect of increasing the current. Both actions result in a greater flow of charge carriers through the wire.

Related Questions

Should wire tapping be allowed?

Yes


In what instances can wire tapping be done?

when police are investigating and have a warrent


What is the matter that that can be formed into a tube or wire?

the matter that can be transformed into a tube or wire is called ductile.


Why is cooper wire better than a rubber tube is?

it has better wire than a rubber tube


Two methods of active wire tapping are between lines transmission and?

piggyback entry


What is the different types of chest tube thoracotomy?

guide wire tube thoracostomytrocar tube thoracostomyoperative tube thoracostomy


Can you reinsert guide wire to blocked NG tube?

You should never reinsert the guide wire into an NG tube. If reinserted into the NG tube, it can puncture through the tube and perforate the esophagus. You should follow your doctor (or whoever ordered the NG tube) ordered flushing instructions only.


What is a wire?

itis a tube with electricity that produces energy


Where is the coolant sensor on a 2001 Ford Taurus?

Check around the reservior for a wire harness going to there. Try tapping on it.


What parts do I need if my sister boyfriend cut every single wire and tube in my dodge caliber?

Sounds like you'll need to replace or repair every wire and tube that was cut.


When I turn key off blower motor does not com back on unless I tap on heater box?

There is a loose wire somewhere in the circuit - tapping the heater makes the wire complete the circuit !


What is a draw tube?

A Draw Plate is a small hardened steel plate with a number of different sized holes in it, and is used for drawing wire through it in order to make smaller wire. The same technique is used to draw tubes down to a smaller diameter.This cold-working method results in a tube/wire with a good surface finish, and also improves a little the properties of the tube/wire.