0
What else can I help you with?
Why is your samsung dryer not getting heat?
Probably, it's not getting any (or enough) power.CAUTION: That is a 220v 3-phase feed line and can give vicious burns and sometimes FATAL shocks.Try the following:1) Make sure that the appliance is plugged in properly.2) Reset the Circuit Breaker that feeds the appliance a couple of times.If that does not work and you have no experience working with High Voltage Electricity, Call For Service.3) Check (or have checked) the Voltage in the 3-phase plug for the drier.
What is The Voltage Of each wire in Straight 220V Circuit?
Voltage is not an absolute figure. Voltage Difference is the exact term. So, the voltage difference between the two wires in the 220 V circuit will be 220V.
Will a device designed for 110v work on 220v?
No, a device designed for 110v will not work on 220v without a voltage converter.
Can a device designed for 110v work on 220v?
No, a device designed for 110v cannot work on 220v without a voltage converter.
How can you make a 240 volt 60 cycle Clothes dryer work on a 220 50 cycle system?
You would need to use a transformer to step up the voltage from 220V to 240V. However, changing the frequency from 50Hz to 60Hz is more complicated and may require a frequency converter, which can be costly and may not be practical for a household appliance like a clothes dryer. It's recommended to consult a professional electrician before attempting to modify the electrical system.
How do you calculate the resistance of a heater element that's uses 220v and draws 11amps?
The equation you are looking for is R = E/I.
Can a 240v be plugged in to a 220v socket?
In some parts of the world, an 1875 watt hair dryer can and does use 220 volts from a 220 volt outlet?
What type of electrical outlet is required for a 220v dryer plug?
A 220v dryer plug typically requires a special type of electrical outlet called a NEMA 14-30 outlet.
Can you use a 250v Hair Dryer in a Europe outlet with 220v?
Yes, you can.
A TV 220V 100W what is the current it draws?
100/220 = .45A or 450 mA
An electric iron always draws a current of 3.4 amp from the 220v supply line what current will this electric iron draws when connected to 110v supply line?
1.7amp
A resistor has a resistance of 176 ohm How many of these resistors should be connected in parallel so that their combination draws a current of 5 amperes from a 220 volt supply line?
4 resistors were connected in parallel it yields 5A of current from 220V supply.
Did you burn up your motor if you plugged in 220V to a 110V?
Yes, although you might have lucked out and tripped the breaker first.
Can you plug a power-bar on a 220V to 110V converter?
The power-bar must be plugged into the correct voltage it was designed for.
A clothes dryer uses 5500 w of power when connected to a 220-v ac line how much current does the dryer draw from the line?
5500Watts/220V=25 Amps
The problems of electricity two light bulbs of 100 watt and one 60 watt both operation in a 220V circuit. Which bulb has the higher resistance and which bulb carries the greater current?
A 100 watt 220 volt light bulb (or anything consuming 100 watts on 220 volts) draws 100/220, or .45 Amps. It will also have about 220²/100, or 484 ohms resistance. A 60 watt 220 volt light bulb (or anything consuming 60 watts on 220 volts) draws 60/220, or .27 Amps. It will also have about 220²/60, or 807 ohms resistance.
Can you convert a 220 dryer into a 110 dryer?
Yes, it's called a step-up transformer because, if I understand correctly, you want to step up from a 110v power source to run a 220v dryer. Depending on the power (wattage) rating of the dryer, it will probably cost as much as having 220v service installed by an electrician. Furthermore, the 110v circuit must be fused for at least twice the current rating of the dryer, assuming the transformer is 100% efficient. This is because Power = Voltage x Current. If you halve the voltage (220 --> 110), you must double the current in order to maintain the same power rating. For example, if the dryer normally draws 20 amps at 220 volts, it will require at least 40 amps from a 110 volt circuit. This would require a 4000 volt-amp transformer-- a very pricey item indeed. If you opt for such a unit I would certainly consult a certified electrician.
