The length of a typical bus ranges from 30 to 45 feet, but articulated buses can be longer, usually around 60 feet. The specific length depends on the model and purpose of the bus.
Neither! I'd rather be hit by a bus moving at 2 MPH than by a bicycle going at 40 MPH. But the point of the question is, which has more momentum and kinetic energy? If both the bus and the bike are moving at equal speeds, then you'd stand less chance of serious injury being hit by a bike, because the bike has less mass and therefore less momentum and kinetic energy. However, a lot of bikes have a great many sharp points and corners, while the average city bus is more flat-faced. On the other hand, if you get run over by a bike, it'll get your shirt dirty. If you get run over by a bus, it's likely to crush you.
To convert aluminum bus bar length to kilograms, you will need to know its density. The density of aluminum is approximately 2.7 g/cm³. Calculate the volume of the bus bar using its length, width, and height dimensions, then convert the volume to kilograms using the density. A simple formula for this conversion is: Mass (kg) = Density (g/cm³) x Volume (cm³) / 1000.
The potential energy of a bus typically changes into kinetic energy for the bus to move. When the bus starts moving, the stored potential energy is converted into the energy of motion, resulting in the bus's kinetic energy.
The momentum of the bus would increase by a factor of three since momentum is directly proportional to velocity. The bus's momentum is equal to the product of its mass and velocity.
An object that is 10 meters in length can be a small bus, a compact car, or a large recreational vehicle.
A snake
most likely not. Depends on the size of the school bus and the size of the tape measure. Other than that, I don't know
Most likely , they're used for powering lights in the bus stop shelter.
The question doesn't tell us what the length of the bus was before it left the garage. Whatever that length was,we would measure the bus to be about 4.2% of that length as it whizzed by.And the people on the bus would measure us to be about 4% of our normal thickness as they whizzed by.
Most bus companies would likely allow a cat on a bus if it is in a cat carrier, but if unsure it may be best to contact the bus company.
bus
The length of time it would take to get from Alberta to Toronto by the bus will depend on how many stops the bus makes. The average length of time is between 36 and 48 hours.
The length of a standard school bus is typically about 10 to 12 meters. To convert this to kilometers, it would be approximately 0.01 to 0.012 kilometers. However, the exact length can vary based on the specific bus model and configuration.
It would be no different than parallel parking a car, except you have more length to deal with, and you're more likely to have to actually get out and look, or have someone guide you in.
Technically, you can use any measure of distance you like. feet or metres is most likely the answer your homework is looking for.
It depends. I pesonally would like for a guy to get eairly to class and ask me then. On the bus would be way to crowded and loud! She be way more likely to say yes in class but not with everyone watching so she isn't pressured.
The length of a single bus is best measured in metres.