answersLogoWhite

0

The broom standing on its own is typically observed during the Spring equinox, around March 21st. However, it can stand on its own at any time of the year with the right balance and technique.

User Avatar

AnswerBot

1y ago

What else can I help you with?

Related Questions

What is the end of a broom called?

The end of a broom is called the bristles or the head.


When did Broom Junction railway station end?

Broom Junction railway station ended in 1962.


Broom of twigs?

A broom of twigs fastened to one end of a pole and used for floor sweeping, is known as a Besom.


Can a broom stand on end in Australia?

A broom is no more likely to stand on end in Australia than it is to stand on end in any other part of the world. There is nothing unusual about Australia that enables brooms to stand on end.


How do you tie a hooey knot?

To tie a hooey knot, start by forming a loop with the rope, leaving a long end (the working end) and a shorter end (the standing end). Pass the working end around the standing end and through the loop you created, then wrap it around the standing end again. Finally, pass the working end back through the loop and pull to tighten. Adjust the knot as needed to secure it.


What is the strength of a funny car?

Speed from a standing start to the end of a drag strip 1,000 feet away.


How is broom works as lever?

A broom works as a lever when you apply force at one end (the handle) to lift or move an object (dirt on the floor) at the other end (the bristles). The handle of the broom acts as the lever arm, and the fulcrum is where the handle connects to the broom head. By pushing or pulling the handle, you can exert a force on the dirt through the bristles to sweep it away.


How much pressure does 600 gallons of water dropped 5 feet through a 3 in pipe exert?

Not very much at all. When the "start" of the water flow hits the end point it will be very low; but the weight if the water itsself will be very high.


Why is a broom a lever?

A broom can be considered a lever because it has a long handle that allows you to apply a force at one end to lift or move objects at the other end. The handle acts as the lever arm, and the fulcrum is where you hold the broom. By pushing down on the handle, you can exert a force on the bristles to sweep the floor.


A broom is an example of machine where are the input and output forces applied?

The applied force to the end of the handle is the input force and the output force is when the broom sweeps over the floor.


How do you tie a Sumac Knot?

To tie a Sumac Knot, start by forming a loop with the working end of the rope over the standing part. Wrap the working end around the standing part and then through the loop you created. Pull the knot tight while holding the standing part. The Sumac Knot is useful for creating a secure loop at the end of a rope and is often used in fishing and climbing.


How is balancing the pole end of a broom in an upright position?

Balancing the pole end of a broom in an upright position requires finding the center of gravity by making small adjustments to the angle and position of the broom until it stands independently. Once you locate this point, you can carefully adjust the position to maintain balance. Practice and patience are key to mastering this skill.