answersLogoWhite

0

inside the rocket

User Avatar

Wiki User

13y ago

What else can I help you with?

Continue Learning about Physics

How much air do you put in a bottle rocket?

Approximately 100-150 psi of compressed air is typically used to launch a bottle rocket effectively. It is important to follow safety guidelines and instructions provided with the bottle rocket kit to ensure a successful launch.


What do you put inside a bottle rocket to make it fly?

Baking soda and vinegar are commonly used in bottle rockets to create a chemical reaction that produces gas, propelling the rocket into the air.


Why if you put a scrunched piece of paper on the rim of a bottle and you blow it why does it not go in and pop back out?

When you blow into the bottle, you increase the air pressure inside. This increased pressure pushes against the crumpled paper, keeping it in place on the rim. Additionally, the shape and weight of the paper help to keep it from being pushed into the bottle.


What is the perfect amount of water you should put in a 2liter bottle rocket?

A good rule of thumb is to fill the bottle about one-third to one-half full with water before launching the rocket. This amount of water provides enough mass for propulsion, but not too much that it affects the rocket's flight. Experimenting with different water levels can help you find the perfect amount for your specific rocket design.


What is the right amount of water to put in a bottle rocket so it will go high?

The optimal amount of water for a bottle rocket is typically around one-third to half full. This allows for enough water to create the necessary thrust for launch while also leaving room for air pressure to build up for propulsion. Experimenting with different water levels can help you find the right balance for achieving height.

Related Questions

Why should you choose to put four fins on a pop bottle rocket?

3 are sufficient. Adding more will just create atmospheric drag and slow the rocket down.


How much weight to put in bottle rockets?

The amount of weight needed in a bottle rocket varies depending on the size and weight of the rocket itself. It is important to test different weight configurations to achieve the desired altitude and stability during flight. Start with a small amount of weight, such as a few paper clips, and adjust accordingly until you reach the desired results.


How do you make a pop bottle explode?

you can put some mint mentos in the pop


What do you put on the backstage pass for baby bottle pop when you register?

on a baby bottle package


What is the procedures for a water rocket?

take 2 l. bottle cut the bottom of a bottle off put the 2 bottles together take a piece of balsa wood and make the wings fill the bottom part of the water rocket with paper put the wings on the bottle rocket cut a circular cup in half put a tennis ball on the cup


How much air do you put in a bottle rocket?

Approximately 100-150 psi of compressed air is typically used to launch a bottle rocket effectively. It is important to follow safety guidelines and instructions provided with the bottle rocket kit to ensure a successful launch.


How do you make a bottle rocket with explosion at the end?

put a cherry bomb in it and time it.


Water in a bottle rocket?

get a 2 litre bottle put a cone on top get a lancher then pump it up and BLAST OFF!!!!!


Best shape for a bottle rocket nose cone?

square before you put it together


How does chilled water made?

simply put water in a bottle and pop it in the freezer


How do you make Levi jeans?

you first put a lolipop in a baby bottle pop


Why do you put water in bottle rockets?

A 2-liter bottle will be required, as a 20-ounce is too small. Remove the label and take the cap off, but save this cap. take a pen apart and saw the barrel of the pen in half. Outline the size of the barrel on the top of the cap. Drill a hole this size into the cap. Using cardboard paper, construct 3 or 4 fins for the ship. A foam football cut in half can make the nosecone of the rocket, but a piece of paper can substitute. Once the nosecone and fins are attached, put the pen barrel in the bottlecap, and attach a bike-pump to the pen barrel. Fill the rocket with water, put the cap on, and pump air into the rocket until it blasts off.