The flux of the two regions must be the same because of the law of conservation of mass. This principle states that mass cannot be created or destroyed, only transferred or transformed. Therefore, in a closed system, the total amount of mass entering a region must be equal to the total amount of mass leaving that region in order to maintain mass balance.
In a Transformer, Core flux is the difference of primary flux and Secondary flux which are opposite to each other in direction. There difference is equal to the no load flux at all loads. So, some of primary flux passes through the core and remaining becomes leakage flux (Because Secondary flux forces it to get out of the core). Same is the case with Secondary flux. Now, flux is directly proportional to Voltage and Current. When Current increases due to increased load (and voltage remains same): Then both primary and secondary flux increase. Because both of them increase, so there difference remains same. And all remaining flux is forced out. Hence leakage flux increases with current, but Core flux remains constant. When Primary Voltage is increased: Then only primary flux increases. So difference of this new increased primary flux and previous same secondary flux increases. Hence Core flux increases with voltage, But leakage flux does not. That's how In transformer core flux depends on voltage whereas leakage flux depends on current.
direction
A bipole is a type of electrical switch that has two poles, allowing it to control two separate circuits simultaneously. It is commonly used in applications where two circuits need to be connected or disconnected at the same time.
If two objects have the same density, then their mass and volume must also be the same. Density is calculated by dividing an object's mass by its volume, so if the density is the same for two objects, it means that the ratio of their mass to volume is equal.
When two physical quantities are added together, they must have the same units in order to be combined. This means that both quantities must be expressed in the same type of measurement, such as meters or kilograms, for the addition to be valid.
A graph of two simultaneous linear inequalities in two variables that have no intersecting regions must contain two lines with the same slope.
True
In a Transformer, Core flux is the difference of primary flux and Secondary flux which are opposite to each other in direction. There difference is equal to the no load flux at all loads. So, some of primary flux passes through the core and remaining becomes leakage flux (Because Secondary flux forces it to get out of the core). Same is the case with Secondary flux. Now, flux is directly proportional to Voltage and Current. When Current increases due to increased load (and voltage remains same): Then both primary and secondary flux increase. Because both of them increase, so there difference remains same. And all remaining flux is forced out. Hence leakage flux increases with current, but Core flux remains constant. When Primary Voltage is increased: Then only primary flux increases. So difference of this new increased primary flux and previous same secondary flux increases. Hence Core flux increases with voltage, But leakage flux does not. That's how In transformer core flux depends on voltage whereas leakage flux depends on current.
Two regions with the same climate would likely share similar weather patterns, such as temperature range, precipitation levels, and seasonal variations. This could lead to comparable vegetation types, agricultural activities, and outdoor recreation opportunities in both regions.
Types of flux - Electric and Magnetic Flux. Electric field flux through a closed surface is equal to the change enclosed in the surface, or the rate of change of magnetic flux is equal to the induced voltage around the surface.
Yes they must be in the same units of measurements.
they must have the same point
The two types of flux used in metallurgy are acidic flux and basic flux. Acidic fluxes are used to remove impurities by forming acidic slag, while basic fluxes are used to form basic slag and improve the flow characteristics of the molten metal.
yes
they must be in the same circle or congruent circles they must have the same central angle measure
They must be the same length.
the same culture and the same territory.