A changed electroscope will discharge near a radioactive material because the radioactive material emits ionizing radiation (such as alpha and beta particles) that can ionize air molecules around the electroscope. This ionization causes the charge on the electroscope to leak away, resulting in discharge.
Electroscope can be charged by conduction, where it comes into direct contact with a charged object transferring charge, or by induction, where a charged object is brought close to the electroscope inducing a separation of charges within it.
The current through a material can be changed by varying the voltage applied across the material. By adjusting the voltage, you can increase or decrease the current flowing through the material. Additionally, changing the resistance of the material can also impact the current flowing through it.
Either by the current heating a fine wire until it glows in the incandescent lamp, by an electrical discharge exciting agas or flourescent material in gas-discharge and flourescent lapms respectively, or by a quantum effect in the light-emitting diode.
No, measuring the physical properties of a material does not change the material itself. The properties being observed, such as mass, volume, density, or color, are characteristics of the material and do not alter its composition.
The change in temperature of a material due to heat energy depends on the specific heat capacity of the material. Different materials have different specific heat capacities, which determine how much heat energy is needed to raise their temperature by a certain amount.
Electroscope can be charged by conduction, where it comes into direct contact with a charged object transferring charge, or by induction, where a charged object is brought close to the electroscope inducing a separation of charges within it.
The rate cannot be changed.
Being radioactive and unstable elements they are continuously changed.
No, the average amount of radiation emitted from a radioactive substance is inherent to the substance's decay process and cannot be changed. The rate of decay is measured by the substance's half-life, which is a fixed characteristic of the radioactive material.
Radioactive decay falls under chemistry, because the chemical properties of the substance are changed during radioactive decay.
The original rock material changed to igneous rocks is the lava .,.,,., "I LOVE MY ANSWER'',..,
Atomic nuclei are changed by nuclear reactions or radioactive disintegration.
As all radioactive elements, isotopes of americium continuously decay.
yes, they can be changed by increasing the density of their molecules
The current through a material can be changed by varying the voltage applied across the material. By adjusting the voltage, you can increase or decrease the current flowing through the material. Additionally, changing the resistance of the material can also impact the current flowing through it.
has hats changed over the years
a smart material is a type of material used that can be changed by some of its own probities