Because it is not either cold enough or hot enough.
You can create a partial vacuum at home by using a vacuum pump or by using a manual vacuum pump. Simply connect the pump to a sealed chamber or container, and then pump out the air to lower the pressure inside the chamber, creating a partial vacuum.
Boiling water turns to vapor in the cold because the temperature difference between the hot water and the cold air causes the water to evaporate and turn into vapor.
To create a vacuum in a glass container, you can use a vacuum pump to remove air molecules from within the container. Place the glass container on a vacuum pump, turn it on to create a low-pressure environment, and then seal the container to maintain the vacuum inside. This will remove most of the air molecules from the container, creating a vacuum.
If water vapor becomes extremely cold, it will condense and turn into liquid water. This process is known as condensation and it happens when the water vapor loses enough energy to change state from gas to liquid.
Water will turn into water vapour at any temperature between 32 deg F and 212 deg F - under normal pressure.
You can create a partial vacuum at home by using a vacuum pump or by using a manual vacuum pump. Simply connect the pump to a sealed chamber or container, and then pump out the air to lower the pressure inside the chamber, creating a partial vacuum.
freeze drying However you probably can't afford the necessary equipment: rapid freezer, vacuum chamber.
When placed in a vacuum, water will start to evaporate due to the reduced air pressure. As the pressure decreases, the water molecules gain enough energy to break free from the liquid and turn into water vapor.
turn off the vacuum
The boiling water will evaporate (turn to vapor). The ice will melt (turn to liquid) and then begin to evaporate (turn to vapor). The tap water will begin to evaporate (turn to vapor).
cool it.
You get to the poison chamber by the safari zone. The statues say "To enter the POISON CHAMBER and the MASTER attack the NINJA must turn SOUTH and go BACK. You enter the chamber from behind the chamber. Turn south as in exit the chamber and go back as in enter the chamber from the back.
To turn on the pool vacuum, locate the power switch on the vacuum unit and flip it to the "on" position. Make sure the vacuum is properly connected to the pool's filtration system before turning it on.
To turn on a pool vacuum, first connect the vacuum head to the telescopic pole and attach the hose to the vacuum head. Then, lower the vacuum into the pool and connect the other end of the hose to the skimmer or designated suction port. Finally, turn on the pool pump to start the vacuuming process.
Boiling water turns to vapor in the cold because the temperature difference between the hot water and the cold air causes the water to evaporate and turn into vapor.
212
Condensation