A condenser "condenses" or reduces the volume of gas by cooling it, which causes it to change state from a gas to a liquid. It removes heat from the gas, making it more compact and efficient for various applications such as refrigeration or distillation.
Liebig condenser, Vigreaux column, Snyder column, West condenser, Allihn condenser, Graham condenser, Dimroth condenser, Friedrichs condenser. There are no shortage of these!
The temperature of the water leaving the condenser would depend on the amount of heat removed from the water in the condenser. Without this information, it is not possible to accurately determine the temperature of the water leaving the condenser.
The approach temperature difference (ATD) is used to determine the condenser performance of a water-cooled condenser. It is the temperature difference between the refrigerant condensing temperature and the cooling water inlet temperature. A lower ATD indicates better performance and efficiency of the condenser.
In a total condenser te temperature is lowerd to a level on which all gasses turn to liquids. with a partial condenser you can separate gasses on there dew point. It means that the temperature is set to a level on wich a one or several gasses leave the partial condenser as a liquid and the others as a gas.
The condenser knob in a microscope is used to adjust the position of the condenser lens, controlling the amount of light that reaches the specimen. By adjusting the condenser knob, the user can optimize the illumination and contrast of the specimen being viewed under the microscope.
No I think you will need an 18000 condenser for an 18000 BTU.
Well, there's more than one kind of condenser, and your answer might depend upon which you are referring to.
a/c condenser
A condenser.
Liebig condenser, Vigreaux column, Snyder column, West condenser, Allihn condenser, Graham condenser, Dimroth condenser, Friedrichs condenser. There are no shortage of these!
Which condenser are you asking about? There are a couple things that are called a condenser.
Condenser
Drain the cooling system.Remove the radiator.Recover the refrigerant.Remove the receiver dryer.Remove the condenser inlet hose bolt.Remove the condenser inlet hose.Remove the condenser outlet hose bolt.Remove the condenser outlet hose.Remove the condenser from mounts on the radiator.Remove the condenser...........................
What are the symptoms of an cooled Condenser when the air leaving the condenser is hitting a barrier and recirculating?
when the Liebig condenser was invented
The inside of the air conditioner condenser can be cleaned by removing the hoses and running water through the condenser. Run water through the condenser until the water exiting the condenser is clear.
It is located in the liquid side. Most of the time it is in the evaporator inlet. The other place they are located is at the outlet of the condenser. Follow the line that runs from the condenser ( a/c radiator) to the cab, there should be a nut holding two pieces together. It'll be in there, I think it slides in toward the condenser.