It works with a connected wire and all the components inside a circuit.
A circuit will not work if a switch is open, be because it is not allowing the electricity to flow. Where as if it was closed it would give the electricity a sealed off path to flow through.
Voltage is what drives the current to flow in a circuit, so it provides the potential energy to do work. The current then carries that energy through the circuit to power devices or perform work, such as generating heat or light. Both voltage and current are essential for work to be done in a circuit.
Resistors work by impeding the flow of electric current in a circuit. They do this by resisting the flow of electrons, which reduces the amount of current that can pass through them. This restriction helps to control the amount of current in the circuit, which can be important for protecting components or controlling the overall function of the circuit.
Resistors work in an electrical circuit by limiting the flow of electric current. They are designed to resist the flow of electricity, which helps control the amount of current passing through a circuit. This resistance is measured in ohms and can be adjusted by changing the value of the resistor.
Resistors are electronic components that limit the flow of electric current in a circuit. They work by converting electrical energy into heat. Their role in an electrical circuit is to control the amount of current flowing through different parts of the circuit, helping to regulate voltage levels and protect sensitive components from damage.
Electricity travels in a closed circuit when it does work.
Electricity travels in a closed circuit when it does work.
The work in an electric circuit is done by the flow of electric charge, typically achieved by the movement of electrons through a conductor. Work is done when a voltage is applied to the circuit, causing the electrons to move and transfer energy to the components in the circuit like light bulbs or motors.
A parallel circuit.
No
yes it does have to be a closed circuit
In a series circuit, if one component burns out, the circuit will not work because the current flow is interrupted by the burnt-out component. This is because components in a series circuit share the same current.
No.
because the circuit is not a full circuit so it wont work!
A series circuit will work if there is a closed path through which the current can pass, and a voltage source. Otherwise it won't.
in a series circuit or it will not work. Put it after the bulb
The switch needs to be in the "on" position for the circuit to work, allowing the flow of electricity through the circuit. In the "off" position, the switch breaks the circuit, stopping the flow of electricity.