Less surface area and cross section for the current to travel through.
Short-wavelength sound waves, such as those with high frequencies, produce a high pitch. When an object vibrates quickly, it generates fast compressions and rarefactions in the air, resulting in a high-frequency sound wave that our ears perceive as a high pitch.
Even if the material is the same, the thick lens is stronger because strength increases when thickness increases. If you pull on the lens in its plane and it is twice as thick then it is twice as strong. If you push on the lens perpendicular to it and it is twice as thick then it is eight times stronger. This is strength of materials theory taken in college for engineering.
Opaque materials, such as wood, metal, and thick plastics, are ones that you can't see through because they don't allow light to pass through. These materials absorb or reflect light rather than allowing it to transmit through them.
Cranberries have to bounce 4 inches to be used.
When an incandescent light bulb (the normal round ones that Thomas Edison invented) is placed into a "hot" circuit, (meaning there is electricity flowing through it), the electricity passes through the filament (little metal wires) on the inside. As the electricity passes through it, the wires heat up and make a chemical reaction causing light to be emitted.
I think thick wires are smarter
The positive wires for IAT sensor on a dodge ram are the red ones. The black wires are are ones that serve as the negative cables.Ê
The highest wires on the poles are the ones that carry electricity,the lower ones are generaly phone and cable tv.
Any liquid. Normally thick ones.
The ones that conduct electricity
wierd ones
take the old ones out then put the new ones in im guessing
Yes - very thick ones! You would also need an oxygen tank, a pressure suit a life support system - made with materials that are high in temperature resistance.
a little more clarification is needed. which wires are you talking about? the ones on the engine or on the body/frame.
Ones with a thick tread pattern.
Close... the things they transmitted over the wires were actually sounds. They just called tham dots for the shorter ones and dashes for the longer ones.
Just disconnect the old ones, and install new ones. Make sure that you connected first cylinder to the second coil in the port with number 1 next to it. Do it for all wires.